What are the steps of silicone pad printing?

1, put the printed products in the iron plate one by one. At the same time, the pad printing machine must carefully check the printed products? Transfer printing self-inspection project? Poor conductive appearance, such as missing printing, insufficient conductive printing, thin conductive oil, sticky conductive oil, etc. When printing a plate of products, you should put a label on the blank space of the iron plate? Then put the product on the drying car, fill a car and push it to the inspector for inspection. Three points should be paid special attention to during the operation?

2. When printing products, if the left hand of the print head does not take out the printed products or the right hand does not put the products to be printed properly, take out the hands in time? And immediately press the pedal switch? Avoid squeezing hands or printing defective products.

3. Always check whether there is pad printing oil on hands, furniture and workbench. And keep iron plates, hands and furniture clean at all times.

4. Automatic continuous printing? Pick up the printed product in your left hand and put it in the iron plate? Pick up the product to be printed with your right hand and put it on the set? Keep moving? Step on the foot switch? Press the foot switch to start or stop at any time.

5. Notify the inspector before printing leaflets? And take back the products that need maintenance and those that cannot be maintained in the inspector's office. Use a blade and paper cover to repair before printing. After printing all the repaired products, the printer will put a "finished product" label on the last plate of products? Send this plate directly to the inspector? After the inspector checked the last plate? Fill in the "Production Daily Report" and send it to the team leader for verification and signature before sending it to the dryer.

6. If you don't print flyers after work? Do you need to clean the pad and the machine? Will all the repaired products be repaired? Fill in daily production report and production process leaflet? Then leave the production process leaflets in the semi-finished box, print and fill them out after work, and send them to the pre-inspection? And send this daily report to the team leader.