What is a typesetter?

1. The line embedder is a professional off-line worker in the electromechanical factory.

2. Main responsibilities:

(1) Work objects should be placed firmly and safely. It is strictly forbidden for keys, iron filings and other items and sundries to fall into the motor slot and buried field.

The ground should be kept clean and tidy.

(2) The electrical equipment used is well grounded and should be properly placed to prevent being knocked down. The safety accessories of pneumatic equipment should be sensitive and reliable. hand

Grasp tools (wooden hammer and wedge head). Safe voltage should be used for portable lamps.

(3) When embedding the rotor, the shaft should be perpendicular to the embedding frame to prevent it from falling obliquely. When the line is buried to 1/3, the square timber shall be used to resist deflection.

The face is heavy. When you turn the ground, you should put something on it, and you are not allowed to stand upright.

(4) The coil should be electrically heated with protective measures, and the insulation should be checked. When in use, connect the wires before sending power, and stop the machine.

After cutting off the power supply, disconnect the wires.

(5) Asbestos gloves must be worn when using thermal sheath clasp and slip ring. Don't wear gloves when using a sledgehammer. Multi-person operation should be coordinated.

Work, commanded by one person.

(6) When embedding the stator wire, it is necessary to prevent the thread end from sticking out and insulating paper; The burr of groove edge and groove wedge should be ground off in time to prevent

Slipping will hurt your hand.

(7) A workbench (or ladder) should be set for large stator embedding (or aerial work) and safety measures should be taken. Tools and materials are not allowed to be thrown when passing.

(8) Pay attention to safety and direction when knocking the slot wedge with a hammer. When using mechanical slotted wedge, it should be light before heavy, and pay attention to cooperation.

(9) When the steel wire is tied on the big steel wire tying machine, the center frame should be used; When winding steel wire and adjusting tension, people should stand on the side.

(10) During the withstand voltage test, the "Safety Operation Rules for Electrical Tests" shall be observed, and no one is allowed to enter.

(1 1) The welding of the joint shall strictly abide by the Safety Operation Rules for Tin-lining Workers. The tin spoon used should not leak. Take it away to prevent it from overflowing.

Go out or come down. When welding with an electric soldering iron, the soldering iron should be placed on the heat insulation frame. Unplug the power plug after welding.

(12) Flammable and toxic substances should be properly kept, and direct contact with naked flame, high temperature and hands is strictly prohibited.

(13) When lifting large workpieces, it is necessary to cooperate closely with the hook worker.

(14) During gas welding, the welder's safety operation procedures shall be observed.