Two installation methods of gypsum line

There are two installation methods of plastering line, namely, sticking line method and nailing line method. The specific steps and precautions of these two methods will be introduced in detail below.

Sticking line method

The putty at the grass-roots level must be scraped clean to expose the plastering layer of cement mortar, so as to avoid the gypsum line falling off, and the powder should be adhered quickly. Use point installation, but the interval should not be too large. The most important thing is that after the line is stuck at a certain angle in the corner, you must not be greedy for cheap, and choose poor quality, otherwise it will be prone to yellowing and cracking.

Nailing method

It is necessary to drill two holes 10㎜ in the place where there is a wire slot on the plaster line mold, even if it is two meters long, measure it from both ends to the middle 55㎝, and then put it in the position to be installed. Draw the position of two holes with a pencil, and drill holes with 1㎝ electric hammer. One person holds the plaster line, and the other person uses the self-tapping.