Can I test the water after the toilet is installed?

After the toilet is installed, you can test the water. Fill the toilet tank with water and wait for five minutes to see if there is any dripping on the outer wall. Key points for toilet installation: 1. Installation begins after face-to-face acceptance of the goods. Toilets should undergo strict quality inspection before leaving the factory, such as water testing, visual inspection of appearance, etc. Products that can be sold on the market are generally qualified, but remember , no matter how big the brand is, the goods must be unpacked and inspected in front of the merchant to check whether there are obvious defects and bruises, and whether there is color difference in each part. 2. Check and adjust the floor level. After purchasing a toilet and sealing cushion with the same wall distance, you can start the installation. Before installing the toilet, you should conduct a comprehensive inspection of the sewage pipe to see if there is mud, sand, waste paper and other debris blocking the pipe. At the same time, check whether the floor of the toilet installation location is level. If the ground is found to be uneven, you should install it when installing the toilet. Ground leveling. Cut the drain opening short and make it 2mm-5mm higher than the ground as much as possible if conditions permit. 3. After debugging and installing the water tank accessories, check whether there is any leakage. First check the water pipe and flush the pipe with water for 3-5 minutes to ensure the cleanliness of the water pipe. Then install the angle valve and connecting hose, and then connect the hose to the installed water tank accessories. Connect the water inlet valve and connect it to the water source. Check whether the water inlet valve and seal are normal, whether the installation position of the drain valve is flexible and whether there is any jamming or leakage, and whether there is any leakage of the water inlet valve filter device.