Job Recruitment Website - Job seeking and recruitment - Simulated examination questions and answers for internal auditors of occupational health and safety management system

Simulated examination questions and answers for internal auditors of occupational health and safety management system

Simulated examination questions and answers for internal auditors of occupational health and safety management system 20 17

1. True or false (65438+ 0 for each question, 30 points in total). Please tick the correct answer in brackets. t? , is it wrong? f?

1, which organization must implement? Audit standard of occupational health and safety management system? . (6)

2. When establishing OHS objectives, only the effects of risk assessment and control are considered. (6)

3. On the premise of meeting the requirements of adequacy and effectiveness, the documents of occupational health and safety management system should be written in detail as much as possible to facilitate implementation. (ton)

4. The occupational health and safety management plan formulated by the organization shall be strictly implemented and shall not be changed. (6)

5. Hazard source identification, risk assessment and risk control need to establish procedures, and the results of risk assessment need to be documented. (ton)

6. The occupational health and safety management representative of the organization shall be a member of the top management. (6)

7. The equipment used to measure and monitor the occupational health and safety performance in the occupational health and safety management system should be calibrated and maintained. (ton)

8. The organization shall obtain laws, regulations and other requirements applicable to itself and communicate these information to relevant parties. (ton)

9. Enterprises that have passed the occupational health and safety management system can be exempted from the supervision of relevant state administrative departments. (6)

10. The participation and negotiation plan of employees and their representatives shall be documented and notified to all employees. (6)

1 1. Organizations that strictly implement national laws, regulations and standards may not carry out hazard identification, risk assessment and risk control activities. (6)

12. System documents are internal management regulations of the organization and have nothing to do with external units. (6)

13. Corrective and preventive measures should be taken for accidents and nonconformities, but not for events that did not cause accidents (f).

14, high-speed rotating grinding wheel fragments suddenly flew out, but no one was hurt, which can be regarded as an accident. (6)

15, where is the industry standard? Three at once? Acceptance can also be used as acceptance criteria. ( )

16. Small organizations can use occupational health and safety policies instead of objectives when applying for OHSAS. (6)

17. It is a passive measure to have regular physical examination for employees with occupational diseases. (ton)

18, the occupational health and safety objectives formulated by the organization must be quantified. (6)

19. Internal audit is the first party audit, and external audit is the second and third party audit. (ton)

20. Occupational health and safety training should consider the responsibilities, experience, education level and risks of employees at different levels. (ton)

2 1. Obsolete documents and materials can be withdrawn from the use site as required, but they must be marked properly. ( )

22. Hazard source refers to the source or state that will definitely cause casualties, diseases, property losses and damage to the working environment. (6)

23. The employee representative is the employee's safety and health representative. (6)

24、? OHSAS related parties? Refers to the individuals or groups participating in or affected by the organization's occupational health and safety performance. (ton)

25. The results of the preliminary review shall form a written report, which shall serve as the basis for all decisions on establishing the occupational health and safety management system, and provide a benchmark for organizing the continuous improvement of the occupational health and safety management system. (ton)

26, whether to implement the occupational health and safety management system specification is determined by the organization, once implemented, it must cover the safety and health issues in the organization's activities, products and services. (6)

27.OHSAS risk refers to the combination of the possibility and consequences of a specific dangerous event. (ton)

28. An outdoor unit of an air conditioner fell from a height during installation, and the machine was damaged, but no one was injured, which was an accident. (ton)

29. Being safe from harm is safety. (6)

30. Employee representatives and employee safety and health representatives may be elected or appointed. ( )

Second, multiple-choice questions: (65438+ 0 points for each question, a total of 30 points) You think the most appropriate answer, fill in the brackets.

1, the meaning of hazard identification is (d)

A) Identifying the existence of hazards b) The process of evaluating risks and determining whether the risks are tolerable.

C) determine the nature of the hazard

2, management review should ensure the sustainability of the system. (5)

A) in line with b) appropriate c) effective d) sufficient e) b+e) b+c+d f) a+b+c b+c.

3. The requirements embodied in the policy commitment of the Occupational Health and Safety Management System Specification include (e)

A) The organization's commitment to occupational health and safety objectives and performance improvement.

B) Commitment to continuous improvement, accident prevention and protection of employees' safety and health.

C) Commitment to abide by the current applicable occupational health and safety laws, regulations and other requirements.

D)B+C E)A+C

4. Labor safety and health? Three at once? It means (e)

A) synchronous planning b) synchronous design c) synchronous construction

D) put into operation at the same time e) b+e) b+c+d f) a+b+c b+c.

5. Before implementation, (b) all the recommended corrective and preventive measures shall be carried out through the risk assessment process.

A) hazard identification b) review c) risk assessment d) negotiation E)A+C

6. Determine the unqualified audit standard is (D)

A) occupational health and safety management system specification b) applicable laws, regulations and other requirements

C) occupational health and safety system documents of the organization D)A+B+C

7. The purpose of internal audit is to determine whether the occupational health and safety management system is (D).

A) The arrangement in line with plan b) is correctly implemented and maintained.

C) Effectively meet the organization's policies and objectives d) A+B+C.

8, occupational health and safety management system must be recorded. (5)

A) calibration and maintenance of measuring and monitoring equipment b) improvement of staff training awareness.

C) Changes in documented procedures caused by corrective and preventive measures d) A+B) E) A+C.

9, the scope of hazard identification does not include (d)

A) routine and unconventional activities b) activities of all personnel entering the workplace.

C) Facilities in the workplace d) Contractor's activities in his own workplace.

10, general program file (1)

A) It does not involve pure technical details; B) It shall be operable and detailed.

1 1 According to the Occupational Health and Safety Management System Specification, the consultation and communication activity that employees should participate in and understand is (d).

A) participate in occupational health and safety affairs b) approve occupational health and safety policies.

C) know who are the representatives of occupational health and safety employees and managers d) a+c.

12, the internal auditor should be ()

A) distinguished b) authorized c) qualified in training d) b+C.

13, according to the classification of enterprise employee casualty accidents, major casualty accidents refer to a one-time death toll of ().

A) 1-2 people B)3-9 people C)9- 12 people D) 12-20 people.

14. The accident that the grinding wheel breaks and flies out and hurts people belongs to the accident category. ( )

A) Impact of objects b) Other explosions c) Mechanical injury

15, the management representative must be in. (2)

A) manager b) top manager c) employee representative D)A+B

16, the audit specification for occupational health and safety management system stipulates that records must be kept for years. (4)

A) 1 B)3 C)5 D) self-organization.

17, which of the following situations does not belong to passive measurement (a)

A) internal audit b) accident investigation c) occupational disease investigation d) accident investigation

18. The organization shall formulate and maintain a management plan aimed at realizing occupational health and safety. (3)

A) policy b) plan c) goal D)A+C

19. Organize to evaluate the education level, work experience and training of all OHS employees. (1)

A) ability b) safety awareness c) operation level

20. Which of the following elements cannot establish and maintain procedures? (4)

A) laws, regulations and other requirements b) training, awareness and ability

C) performance measurement d) management review

2 1. Which of the following elements must be recorded? (4)

A) performance measurement and monitoring b) accidents, incidents, nonconformities, corrective and preventive measures

C) records and records management D)A+B+C

22. The content of the nonconformity report filled in by the internal auditor is (E).

A) describe the unqualified facts b) determine the unqualified terms c) unqualified reasons.

How to take corrective measures

23, the purpose of management review is to ensure that the system (b)

A) compliance, necessity and effectiveness b) suitability, adequacy and effectiveness

C) accuracy, possibility and criticality d) comprehensiveness, flexibility and initiative.

24, occupational health and safety management plan should be (c)

A) Regular approval b) Regular inspection c) Regular review

25, the organization to establish occupational health and safety objectives should be aimed at (f)

A) needs of interested parties b) awareness of employees c) internal related functions d) internal related levels.

E)A+B F)C+D

26. For all posts that play an important role in the effective operation of the occupational health and safety management system, (a) of relevant documents and materials can be obtained.

A) Current version b) Approved version c) Practical version

27, full monitoring and measurement data and results of the record, the purpose is to facilitate the subsequent (b).

A) Implement the accident responsibility b) Analyze the corrective and preventive measures c) Find out the causes of non-conformity.

28. According to the Labor Law, laborers have the right to (d) command and force managers to take risks in violation of regulations.

A) execute first and then sue b) ask for instructions from superior leaders while executing.

C) execute it carefully d) refuse to execute it.

29. The organization shall establish and maintain documented procedures to cope with the operation of occupational health and safety policies and objectives without procedures. (2)

A) has deviated b) may lead to deviation c) will not deviate.

30. If the facts are found in the internal audit, it can be determined that the factors in 4.4.7 are not satisfied. (5)

A) the fire escape is blocked; B) The operator fails to wear work clothes and working caps as required.

C) the medicine used for first aid has expired d d) A+B E) A+C+C.

;