How to make a good car stop for computerized flat knitting machine

1) read the disk. If it is not smooth, you can turn off the power again and plug in the USB socket. If you use a Hu Axiang controller, you can switch the storage media (U disk and disk) first, and then start reading the disk.

2) Thread, and adjust antenna elasticity and side antenna tension at the same time.

3) Adjust the mesh according to the proofing requirements. Nervous, etc.

4) Determine the pattern development and the square position of the yarn nozzle. The national flower series is also pre-measured.

5) Hang the cloth (not used for floor lifting machine) and lock the thread (repeated by Flying Tiger Machine) to immediately open and close the auxiliary roller, and the head speed should be less than 0. 40m/s, when the cloth reaches the main roller, the thread lock is released (the flying tiger clicks again). Increase speed, tension, etc.