What are the characteristics and uses of various hammers?

In metal rough machining, it is used to smooth the metal surface, knock out solder joints and welds, rough the very wrinkled metal surface, and conduct high-quality initial straightening of metal plates. ?

Bald hammer?

The size and shape are the same as those of the heavy hammer, but the weight is smaller. Generally used for metal finishing and folding at the door. ?

Double round head hammer. ?

A light hammer is generally used to roughen the fender, the top of the door or column, knock off the folding edge of the door, and correct the positioning clip. ?

Short-headed pick?

Pneumatic pick is used for finishing metal surface, knocking down the small pits left after rough machining to make the surface smooth. One end of the gas ballast is round and the other end is pointed. It is used for inconvenient parts, such as the front fender, for slight chiseling and metalworking, and for shrinking metal surfaces. ?

Long-headed pneumatic pick. ?

One end is a long round tip, and the other end is a round flat head. It is mainly used for straightening thin steel plates after rough machining and leveling local small pits during finishing. It is forbidden to use long-headed pneumatic pick in metal rough machining. ?

Straight chisel pick ?

Used to repair fenders, rims, trim strips, headlight inner frames, engine hoods, etc. Especially in the process of installing body panels and welding strip structural members, the edges of panels and flanges are often trimmed by hand. ?

Curved chisel. ?

It can be used to straighten and finish angular areas, such as rims, decorative parts, fender flanges and the top outer edges of pillars, and also can be used to level off depressions blocked by body brackets or frame members. ?

Long pickaxe?

The long pick has a very long tip and is often used to process the protrusions on the fenders and side plates of the rear roof of automobile doors. ?

Curved light hammer. ?

Used to straighten and correct some concave surfaces, such as the concave surfaces of fenders, headlights, doors and rear roof side panels. ?

Special hammer for fender. ?

This kind of hammer is specially used for roughing some high-protruding metal surfaces, such as fenders, and can also be used for processing reinforcement that only a long hammer can achieve. It can also cooperate with heavy axe and sledgehammer to roughly process the seriously damaged sill plate, wheel cover, coaming, rear roof side plate and bumper beam. ?

A sharp hammer. ?

The circular hammer surface is used for rough machining and straightening, so as to hammer the repair area with greater force. The pointed hammer can be used to straighten right-angle frame elements, bumpers, bumper brackets and other straight structural members. ?

Round head hammer (ball head hammer). ?

There are a variety of quality and size specifications. Ball hammer is used to knock and correct metal parts and knock the rivet head flat. The round flat hammer can be used for all manual sheet metal processing. ?

Hammer. ?

The hammer has great mass and volume. It is often used in high-strength sheet metal processing, such as correcting and straightening the internal structure of a large body, and correcting the support and bracket of the frame, cross beam, heavy body and bumper. ?