How to burn a heat-conducting oil boiler

Boilers burning heat transfer oil generally use coal, oil and steam as fuel and heat transfer oil as medium. The hot oil circulating oil pump forces the medium to circulate in the liquid phase, and the heat energy is delivered to the heat-using equipment and then returned to the heating furnace for reheating, which can obtain high working temperature at low pressure and control the medium operation with high precision. The specific operation steps are as follows:

1, check whether the heating furnace and its surroundings are clean without sundries, and check whether the furnace body, burner, controller, fire hole and smoke (chimney) air duct are normal.

2. Reverse the process equipment and process, and check whether the oil level in the expansion tank is above 1/4- 1/2, and whether the thermometer and pressure gauge are normal.

3. Turn on the power supply of the heating furnace control cabinet, check whether the voltage is normal, and check whether the indicator light and various display instruments are normal.

4. Adjust the main pressure reducing valve and secondary pressure reducing valve of gas to control the pressure at 0.005MPa.

5. Start the heat transfer oil circulating pump (one for use and one for standby, according to the pump operation regulations), and circulate normally for about 0.5 hours after starting the pump to stabilize the pressure.

6, press the burner start button, observe whether the furnace flame is normal combustion, if not ignition, should be troubleshooting, start the burner again.

For more information about how to burn a heat transfer oil boiler, please visit:/ask/d024eb1615833344.html? Zd view more content