Job Recruitment Website - Job seeking and recruitment - What is the average monthly salary of CNC bending machine operators?

What is the average monthly salary of CNC bending machine operators?

There is no specific salary standard. Generally, factories are piecework-oriented, and wages will follow the benefits, but the minimum standard is 3000.

Operation method of CNC bending machine;

1. First turn on the power supply, turn on the switch on the control panel, and then start the oil pump, so that you can hear the rotation sound of the oil pump, but the machine does not perform the action at this time.

2, stroke adjustment, must pay attention to adjust the stroke when using, must be tested before bending. When the upper die goes down to the bottom, there must be a gap of plate thickness, otherwise the die cutting machine will be damaged, and the stroke adjustment is also electric and fast.

3. The choice of bending notch, generally should choose 8 times the width of the plate thickness notch. If you bend a 4 mm sheet, you need to select about 32 cuts.

4. General rear gear adjustment includes electric quick adjustment and manual fine adjustment, and the method is the same as that of shearing machine.

5. Press the foot switch to start bending. Unlike the shearing machine, the mold of the CNC bending machine can be loosened at any time. As soon as the foot is loose, it will stop and continue to descend.

Extended data:

The daily maintenance of CNC bending machine includes the inspection of equipment. According to the advanced, complex and intelligent characteristics of CNC bending machine, its maintenance and maintenance work is much more complicated and demanding than ordinary equipment.

Check whether all fender benders, cover plates and doors operate normally, step on each shaft all the way, observe whether the operation is stable, ensure that the limit switches of all shafts work normally and adjust to the corresponding limit positions, check whether the guide rail is scratched or excessively worn, check whether the guide rail cleaner is damaged, and touch the guide rail to check whether the lubrication is appropriate.

If any abnormality is found, it should be solved in time, so that it is possible to eliminate the fault in the state of tooth eruption, thus reducing all avoidable losses.