Jinan Meilai Decoration Beijing Urban Construction Decoration Flocking Technology

Flocking process 1. As the top coating substrate, it must be firm and free of oil stains. It can be applied on flat or textured surfaces.

2. Use water-based color paste to prepare the color. You can mix it at will, and the amount of color paste should be controlled within 5%.

3. Silk screen or engraving, control the coating thickness within 3mm, fix the selected color pattern mold on the base surface of the object to be coated, and then scrape coat, wait for the surface to dry for about 30 minutes to 1 Use a hot air blower with a heat exceeding 80 degrees Celsius to heat and dry within an hour until strong adhesion is achieved and the painting is completed with a full and rich pattern.

4. Paper bubbling is a common problem, mainly caused by uneven glue application when pasting wallpaper, which later causes the wallpaper surface to shrink and separate from the base layer due to excessive moisture.

Some built-in bubbles appear as a result.

In fact, the solution is very simple. Just use an ordinary sewing needle to pierce the bubbles on the surface of the wallpaper to release the gas, then use a needle to extract an appropriate amount of adhesive and inject it into the pinhole, and finally Just flatten the wallpaper again and let it dry.

5. Scrubbing of wallpaper: Use a damp cloth or dry cloth to scrub the dirty areas; do not use some colored materials to contaminate the wallpaper, otherwise it will be difficult to remove; wipe the wallpaper in some remote corners or Start in a hiding place behind the door to avoid adverse reactions and damage to the wallpaper.

National owner decoration exchange group

573032185