Handmade method of wooden scabbard

The manual manufacturing method of wooden scabbard is as follows:

Method one

1. Choose suitable size of cypress (length, thickness, quality, etc. ). Saw the wood from the middle.

Be careful when sawing, don't deviate from the center line, and put a mirror opposite to observe.

3. Put the blade on the cut wood, mark the position of the pin, and draw the circuit diagram of the whole blade.

4. Dig a suitable groove with a plane at the line drawing place. This position is very important. One of the reasons for making this groove is to make the blade have a margin in the sheath.

5. Second, it can make dirt have a place where it doesn't exist on the sheath wall, which is also beneficial to the air circulation in the sheath.

6. Because the scabbard is the "pajamas" of the sword, it protects the sword, so it is also very particular when using glue. You can't use chemical glue because chemicals are corrosive to swords.

7. First, plan an ideal approximate shape. The cross section of scabbard is divided into ellipse, smooth ellipse, round ridge octahedron, chamfered octahedron and pointed ridge octahedron), and then trimmed with a small plane. Sheath surface grinding treatment-using natural plants to play a grinding role. At this point, a complete scabbard has been made.

Method 2

Tools: wood, chainsaw, planer, carving tools.

Manufacturing steps:

1. Put the selected plate on the chainsaw for measurement. Saw the board according to the set size and plane all sides. Further pressing with a planer. Adjust the planer to planer degree 1.6 and press the planer board.

2. Dig out the groove on the scabbard. Adjust the distance between platens according to the width of platens. After the groove of the scabbard is planed, stick the two plates of the scabbard together with white latex, and align them when sticking, so as not to affect the future operation. Dry for three to four hours, and then polish.

3. Plane the four sides with a planer, put the scabbard in the middle, round and lubricate the edges and corners, and polish them with 80 mesh sandpaper with a sander.

4. Carving, you can choose different types of knives to carve along the ink line according to the pattern. Sandpaper is used to polish the edges and corners produced by carving, and the scabbard is finished.

The manufacturing method of the wooden sheath (the manufacturing method of the wooden sheath) has been explained above. This article has been shared here. I hope I can help you. If the information is wrong, please contact Bian Xiao to correct it.