What is the main job of the wiredrawing operator recruited by Hengtong Optical Fiber?

It should be the operator pulling the wire, that is, putting the pole on the pulling tower, which is about 30 meters high. The middle of the tower should be divided into several floors. The following is the curing system of the coating system of the cooling tube of the wire drawing furnace, then it passes through PMD and finally reaches DDW, where the rod is divided into 80120150185 200. Depending on the size of the drawing furnace, the rod will melt when it is discharged. If it is thin, it will be in a filament state directly, and then the operator will thread the filament above the fuselage, and a pair of drawing wheels will pull the optical fiber to a specified diameter, and then the operator will thread the filament through the fuselage curing system PMD DDW, install the take-up reel and fix it on the take-up reel, which means that the machine will run automatically. The operator only needs to see if the parameters of some of the above instruments meet the specifications. This is normal, but there may be some accidents in the middle, and sometimes it may even be necessary to cut the cone or thread the silk again, so I don't need to say more here.