What is the staffing configuration of electricians on duty in the 10KV power transformer and distribution room?

Three shifts, with at least two people in each shift, one person operating and one person supervising. This is the rule. If possible, join the regular day shift and be the squad leader. All staff must hold high-voltage operation certificates and network access certificates. There is no need to separate high-voltage and low-voltage. Holders of high-voltage certificates can operate low-voltage equipment. ?

Supplement: The network access certificate is issued by the State Electricity Regulatory Bureau (must have), and the operation certificate is issued by the State Administration of Work Safety (must have). In addition, only the operation certificate has high voltage and low voltage. points, your substation changes from 10KV to 0.4KV, which means it is the lowest level in the high-voltage operation certificate. The above two certificates must be present and are clearly stipulated.

As for whether there is a grade certificate (qualification certificate), there is no explicit regulation. It is issued by the Ministry of Labor. It can only indicate the technical level of the certificate holder. But now students who have just graduated from technical schools can get a senior certificate. As long as you pay enough, they can issue you a senior technician (grade certificate) or senior engineer (professional title certificate) certificate. Therefore, the current grade certificate has no gold content.

Extended information:

Safety regulations

1. The electrician on duty must have the necessary electrical knowledge, be familiar with safe operating procedures, and be familiar with the power supply system and distribution room. The performance and operation methods of the equipment. And have the ability to take measures under abnormal circumstances.

2. Electricians on duty must have a high sense of work responsibility and strictly implement various system regulations such as the duty inspection system, the switching operation system, the work ticket system, the safety equipment and fire protection equipment management system, and the access system.

3. Personnel allowed to inspect high-voltage equipment alone and serve as guardians must be approved by the leader of the power department.

4. Regardless of whether the high-voltage equipment is powered or not, the person on duty is not allowed to move alone or go straight over the barrier to work. If it is necessary to move the fence, a guardian must be present and the safety distance must be met when the equipment is not powered off.

5. When inspecting outdoor high-voltage equipment during thunderstorms, you should wear insulating shoes and stay away from lightning arresters and lightning rods.

6. When inspecting the power distribution device and entering and exiting the high-voltage room, the door must be locked.

7. When contacting the "dispatcher" of the power supply unit or user to perform power shutdown, power transmission and switching operations, the person in charge on duty must check and make a record of the contact content and contact person's name.

8. When there is a power outage, the oil switch (or load switch, etc.) must be used. The load side knife gate and bus side knife gate are operated in sequence.

Baidu Encyclopedia--Electrician

Baidu Encyclopedia--Power Distribution Room