The display of the infrared stone cutter will not move.

The general reason is that there is something wrong with the host. After sale, please ask the manufacturer to check whether the data inside is normal. If it is abnormal, let it be reset or repaired. Stone cutting machine operation procedures:

1. Put on work clothes and goggles. Women's trade unions wear long hair and work hats.

2. Check the power switch, tightness of saw blade, saw blade protection device or safety baffle in detail. The operating platform must be stable, and there should be enough lighting for night operation.

3, turn on the main switch, no-load test run a few times, to confirm the safety before starting.

4, it is forbidden to wear gloves. If dust is generated during operation, please wear a mask or face mask.

5. Don't try to cut and saw small unclamped workpieces.

6. This cutting machine only allows cutting profiles.

7. Strong sawing operation is not allowed, and the motor should reach full speed before cutting.

No one is allowed to stand behind the saw.

9. Don't bend over or bypass the sawing machine, and don't loosen any hands or lift your arms from the saw or workpiece before the saw blade stops.

10. Do not operate when the protective cover is not in place, and do not put your hands within the range of 15cm of the saw blade.

1 1. Before repairing or replacing accessories, please cut off the power supply and wait for the saw blade to stop completely.

12. If any abnormal sound is found, the inspection shall be stopped immediately.