Wallpaper laying steps

Before the shop is stuck, check that the wall surface is clean and smooth, and the surface of the wall skin is free from loosening and falling off.

Selection tool

Use wallpaper or other special tools for wallcovering, and it is best to choose wallpaper knife which is professionally imported.

Roller brush wall basement membrane

First, roll the basement membrane on the wall and adjust the seamless wall covering adhesive in proportion. Note: 2.5 kg of water is added to 2 kg of rubber several times. Do not add water for the first time, and stir well. Add 0.5 kg of water for the second time and stir well. Add 0.5 kg of water for the third time and stir well. Add the remaining water for the fourth time and stir well. A bucket of glue can stick 25-30 square meters)

Rolling wall cloth adhesive

After the basement membrane is dried, wall covering glue is rolled from a certain internal corner of the wall, and wall covering is usually pasted after the wall is evenly rolled.

Straighten wall covering

Straighten the wall covering along the wall, and the height of the upper side is the same as that of the wall. The lower end is padded with articles, and the whole roll of wall covering is at the upper end of the baseboard.

Scrape wall covering.

Roll out the wall covering and scrape it on the wall with a scraper, from the inside out. Stick the wall covering up and down and continue to spread it out in order.

Handle internal angle

If the inner corner is straight, the above rolling construction can be continued without cutting. If the inner corner is not straight, it can be overlapped and cut at the inner corner.

Two people cooperation

If two people cooperate, it will be faster. You can measure the length from the inner corner to the inner corner, leaving a little space to straighten the two ends of the cloth from top to bottom and scrape it from inside to outside.