Changsha cygnet washing machine after-sales maintenance telephone

Changsha Uni-President Little Swan Washing Machine Service Phone (073 1) Area Code -(82 18)- mantissa -(6624) Troubleshooting methods of factory maintenance points in Furong District, Yuhua District, Tianxin District, Kaifu District and Yuelu District: (073 1)-

(1) Maintenance items: no water inflow, continuous water inflow, no dehydration, no dehydration, no bucket collision, no drainage, no impeller rotation, and no motor sound. ...

Cygnet automatic washing machine-stop the water inflow when the water does not reach the set water level.

Analysis and maintenance: This fault is mainly due to the poor performance of the water pressure switch, so that when the air pressure in the gas collection chamber does not reach the specified pressure, its contacts will switch from the off state to the closed state in advance to stop water inflow. The specific reasons and treatment methods are as follows:

(1) The pre-compression of the water level control spring of the hydraulic switch is small, which can be solved by screwing in the adjusting screw to increase the pre-compression of the water level control spring. If the elasticity of the water level control spring becomes smaller or loses its elasticity, the water level control spring should be replaced.

(2) The groove on the cam of the water pressure switch is worn or damaged, which can only be solved by replacing the cam.

Cygnet automatic washing machine-slow drainage speed

Analysis and maintenance: This fault is generally caused by incomplete opening of the drain valve or poor drainage pipeline. The specific reasons and treatment methods are: (1) sundries in the drain valve are blocked or the drain hose is bent and deformed. As long as the debris in the drain valve is removed or the drain hose is replaced, it can be solved. (2) The gap between the drainage rod and the rubber valve becomes larger, as long as the gap between the drainage rod and the rubber valve is appropriately reduced. (3) The spring in the drain valve is too long or loses its elasticity. Just replace the inner spring. (4) The damping of the moving core of the drainage solenoid valve is too large or the suction force becomes smaller. Remove the rust and dirt from the electromagnet, or replace the drainage solenoid valve.

Cygnet automatic washing machine-poor drainage

Analysis and maintenance: this fault is generally due to poor performance of hydraulic switch or air pipeline leakage, which reduces the air pressure in the gas gathering room. When the water level in the bucket has not dropped to the specified position, the contact of the hydraulic switch moves ahead of time, which shortens the total drainage time and leads to unclean drainage. Just try to find the air leak in the air pipe and seal it with 40 1 glue. If the water pressure switch is damaged, please replace it.

Little Swan automatic washing machine-after dehydration, the braking time is too long.

Analysis and maintenance: The fault is that the brake belt can't hold the brake wheel of the dewatering shaft tightly, which reduces the braking friction. The specific reasons and treatment methods are:

(1) The brake band on the clutch is installed askew, the lining is worn or the fastening screw is loose. Just reinstall or replace the brake band.

(2) The brake spring is loose, broken or inelastic. Just reinstall or replace the brake spring.

(3) The brake lever is clamped by the pawl fork and cannot return, so that the brake belt cannot hold the brake wheel of the dewatering shaft tightly. As long as the position of the pawl fork is adjusted, repaired or replaced.

(4) The moving iron core of the electromagnet is blocked by sundries and cannot be fully extended, so that the brake lever cannot be restored to its original position. As long as the rust and dirt on the moving core of the electromagnet are removed or the electromagnet is repaired and replaced.