When hot drilling, I accidentally burned the white pad paper. Is there any way to remove it?

You can wet it with some water mixed with detergent, and then buckle it down bit by bit. If the buckle is harmful to the hot drilling pattern, it can be re-ironed locally.

Share the correct hot drilling steps: 1. Peel off a layer of textured white substrate under the hot drilling pattern, and then stick the sticky paper with the hot drilling pattern on the clothes where you think it is appropriate, and flatten it by hand to make the sticky paper with the hot drilling pattern stick on the clothes. [Glue edge down] 2. Turn the electric iron to the first gear of "cotton" [equivalent to 150 degrees], and dry iron the steam iron without turning on steam or water. Put the clothes on a flat working surface. Sometimes in order to iron more firmly, you can put another layer or two towels on the operating surface. Press the iron hard on the heat map for about 13 seconds. If the heat map is large, the electric iron cannot be covered at one time. Move the iron repeatedly on the heat map to make the whole heat map evenly heated. At the same time, the ironing time is correspondingly prolonged. 3. After ironing, remove the sticky paper on the surface after the ironing diagram cools, and a beautiful ironing diagram is completed.