What should I do if there is water leakage under the mop pool?

If the sewer pipe may burst, immediately close the valve of the water supply pipe and report to the local property department for maintenance; It is also possible that the amount of water is suddenly too large when the washing machine is dehydrated. Consider changing the height of the two drains to the same. Specific practices are as follows:

The leakage of the mop pool may be the burst of the sewer pipe, and the leakage after the burst of the water pipe is generally directly related to the water pressure in the pipe. Whether it is dripping or gushing out, what we can do at this time is to immediately close the valve of the water supply pipe and report it to the local property department for repair to reduce losses. If the burst situation is not so serious and the burst point is found, we can wrap up the damaged part of the water pipe with special tape for repairing the water pipe. In addition, glass fiber tape or epoxy resin glue can also be used to repair cracks in water pipes. However, if the water pipe bursts seriously, the broken part of the water pipe can be wrapped with a towel, which can not only prevent water from spraying everywhere, but also introduce water into the placed bucket to avoid huge waste. At the same time, the valve of the main water pipe in the house can be closed, and the tap water supply in the house can be completely cut off.

Another possibility is that the drain pipe of the mop pool and the drain pipe of the washing machine are shared, and then when the washing machine is dehydrated, the water suddenly becomes large, and the drain pipe is blocked or the water flow is too slow, which will cause water to flow back to the mop pool. In this case, it can be considered that the height of the two drains is the same. Generally, the washing machine will be placed directly underground. After backwater occurs, a table can be built under the washing machine to improve the height of the drain of the washing machine. The second method is to connect the drainage of the washing machine directly to the mop pool. Put the mop pool directly above the floor drain, and then put the water pipe directly inside the floor drain, but pay attention to the filtration measures. Just drain the washing machine water directly into the mop pool. This can not only reuse the water of the washing machine, save water resources, but also solve the problem of drainage overflow.