How to replace consumables in unmanned washing machine

The spare parts replacement steps of Daoda unmanned washing machine are the same as those of the traditional washing machine, and the specific operation steps are as follows:

Unscrew the fixing screws at both ends, unplug the dirt suction pipe, and remove the whole dirt suction scraper from the washing machine body;

2. Remove the two screws in the middle of the suction scraper and loosen the adjusting screw at one end of the suction scraper to facilitate the disassembly of the fittings;

3. Remove the metal clip and the water-absorbing adhesive strips on the inside and outside;

4. Install a new absorbent rubber strip on the absorbent steak, and the hole on the absorbent rubber strip is aligned with the buckle on the absorbent steak. Pay attention to distinguish between the water-absorbing rubber strips on both sides, the edge of the inner rubber strip is serrated, and the edge of the outer rubber strip is flush without sawtooth;

5. After installing the absorbent tape, install the removed screws, install the metal clips, and tighten the adjusting screws to ensure the fittings are fixed.

6. Finally, put the suction scraper with the changed rubber strip back into the washer, clamp the screws at both ends into the groove, tighten the screws, and plug in the dirt suction pipe.

Note: 1. When replacing, pay attention to distinguish between inner and outer absorbent strips, which have serrations inside and no serrations outside;

2. Install the rubber strip and fix the metal clip, and pay attention to the buckle on the suction scraper.