Who is responsible for the leakage of aging water pipes?

We should judge who is responsible according to who maintains the water pipes, because aging also belongs to the maintenance category.

1. If in the property management contract, the water pipes located downstairs are maintained by the property, then the property shall bear the responsibility.

In order to facilitate the management of some high-rise residential areas, these rooms are usually locked by relevant departments. Then, who cares about this key, the toilet is placed in a unified way, and the electric meter is placed in a unified way. The master can't get in at all. If you want to go in, you need to go through the property or who is responsible for the maintenance and who will bear the responsibility.

Extended data:

The first solution to water pipe leakage: avoiding the problem of underwater electricity use

1. Press the water pipe on the pipeline. If the water pipe leaks or water drops appear on the pipe wall, the wires in the pipe may be soaked, resulting in water leakage.

2. Method: It is forbidden to press the water pipe on the pipeline. First, we should distinguish between water pipes and pipelines. The thick pipe marked with red line is hot water pipe, the thick pipe marked with blue line is cold water pipe, and the thin pure white pipe is pipeline.

The second scheme to solve water pipe leakage: do a good job of pressure test

1. Some construction teams don't need a booster pump, but use the naked eye to observe the water leakage of the water pipe to judge whether the water pipe joint is qualified. There is no guarantee that the water pipe will not leak when the water pressure increases.

2. Method: After laying the water pipe, close the valve of the water meter, and seal all the outlets to be suppressed with plugs, leaving only one entrance. Connected to the compressor at the inlet, this is a simple hand pump.

3. Press the air pressure in the water pipe to 6-8 atmospheres (0.6-0.8 MPa) for more than 30 minutes.

4. During this process, it is necessary to observe that the pressure drop is not greater than 1 atmospheric pressure, and there is no water leakage in all joints and valves. After decompression for 2-3 hours, the tube can be sealed.

The third solution to water pipe leakage: it is forbidden to solve water and electricity problems in the same tank.

1. Water pipes and pipelines are buried in the same ditch, which has potential safety hazards. Because water is a conductor, if it leaks electricity, the whole building will be charged.

2. Method: Water and electricity must be placed in different tanks, and the distance is preferably 15cm, which is safer.

The fourth scheme to solve the water pipe leakage: put an end to the cross problem of water pipe and gas pipe.

1。 When water leaks, the gas pipeline is pressed under the water pipe, which is easy to cause water pipe leakage or gas leakage.

2. Methods: The distance between gas pipeline and tap water pipeline should be greater than 10 cm, which is a safe distance and can reduce the risk index.