How to adjust the cement slurry for floor tiles?

Many people will choose to lay floor tiles in the living room, kitchen, bathroom and other areas, which is not only waterproof, but also easy to take care of. Cement slurry is usually used when paving floor tiles, so how to adjust the cement slurry for paving floor tiles? Let's study with Bian Xiao.

How to adjust the cement slurry for floor tiles?

1, the floor tiles are usually laid with cement slurry, which is generally made by mixing cement, sand and water in the ratio of 1:3:0.6. Before laying floor tiles, the ground base should be cleaned without mortar, dust, oil stains, etc., and water should be sprayed to keep the ground moist. If there are irregularities in the ground base, it is necessary to dig and repair.

2. Turn on the level meter again, modulate the ray height of the level meter with the ground level, then spread the modulated cement slurry on the ground, and then wipe the cement slurry evenly with the mud board. When laying floor tiles, it is appropriate to keep the thickness of cement slurry between 3 cm and 5 cm.

3. Before laying the floor tiles, be sure to soak them in water, dry them in the shade and dry them naturally. After the floor tile is dried in the shade, it is necessary to clean the back of the floor tile, and then start laying the floor tile. After the floor tiles are laid, they need careful maintenance and protection. Generally, it needs watering after 24 hours, and it needs to be covered with sawdust for maintenance after laying.

4. Before laying the floor tiles, it is generally necessary to try to spell the tiles to see whether the color of the tiles is consistent with the color, color and number purchased by the owner, and whether there will be color difference. If you have any questions, you must give feedback in time. Don't wait until the laying is completed, it will be too late.

5, floor tiles must be fully soaked, and naturally dried in the shade, otherwise it will affect the condensation and hardening of floor tiles, which will easily lead to the phenomenon of empty drum and shelling of floor tiles. After the floor tiles are laid, it usually takes about three days before people can walk on them.

The above is a detailed introduction on how to adjust cement slurry for floor tiles, hoping to help friends who are decorating. In order to ensure the construction quality and effect of floor tiles, it is suggested that you must ask professionals to help lay them, so as to achieve good results.