Self-inspection report on safety hazards of fire extinguishers

# Report # Introduction With the continuous progress of society, people use self-inspection reports more and more, and self-inspection reports are the treatment methods adopted according to the situation. The following is a self-inspection report on the safety hazards of fire extinguishers compiled by KaoNet. Welcome to read!

1. Self-inspection report on safety hazards of fire extinguishers

The management unit for the use of buildings (places) shall designate special personnel to carry out daily inspection of fire extinguishers, and train employees in the operation and use of fire extinguishers according to the instruction manual provided by the manufacturer. The daily inspection of building fire extinguishers can be divided into inspection and inspection (measurement). Patrol is to check the intuitive performance of fire extinguishers within the specified period, and inspection (measurement) is to conduct a comprehensive inspection of the configuration and appearance of fire extinguishers within the specified period according to the technical standards for fire control.

(1) check

1. Inspection contents: including fire extinguishers' configuration points, quantity, appearance, maintenance marks and fire extinguisher pressure indicators, etc.

2. Patrol period: key units patrol at least 1 time every day, and other units patrol at least 1 time every week.

3. Inspection requirements:

(1) The configuration point of the fire extinguisher meets the requirements of the installation configuration diagram, and the configuration point and its fire extinguisher box are equipped with luminous indicating signs that meet the specified requirements.

② The number of fire extinguishers meets the requirements of configuration and installation, and the pressure indicator of fire extinguishers points to the green area.

(3) The appearance of the fire extinguisher has no obvious damage and defects, and the lead seal (plastic tape and iron wire seal) of the safety device is intact.

(4) After the fire extinguisher is repaired, make maintenance marks according to regulations.

(2) check

Check (test) the content

Check the configuration and appearance of fire extinguishers comprehensively. For details, please refer to Table of Inspection (Measurement) Contents and Requirements for Building Fire Extinguishers.

Inspection cycle

Conduct 1 comprehensive inspection on the configuration and appearance of fire extinguishers every month, and conduct 1 inspection every two months on fire extinguishers in crowded public places such as waiting rooms (airplanes, ships), song and dance entertainment, and places such as yards, tank farms, petrochemical plants, gas stations, boiler rooms, basements, etc.

examination requirements

The configuration and appearance of fire extinguishers shall be comprehensively inspected according to the above Table of Inspection Contents and Requirements for Fire Extinguishers in Buildings, and detailed records shall be made and filed during the inspection.

The fire extinguisher after inspection or maintenance shall be placed according to the original configuration point position and configuration requirements.

In the inspection, it is found that the fire extinguisher has been moved, parts are missing, obvious defects or damage, and the use nature of the fire extinguisher configuration site has changed, which shall be disposed of in time according to the procedures specified by the unit; Meet the maintenance conditions, timely repair; If it reaches the scrapping conditions and service life, it shall be scrapped in time, and shall not be used, and a fire extinguisher that meets the requirements shall be used for equivalent replacement.

2. Self-inspection report on safety hazards of fire extinguishers

1. The safety problems found in the inspection are now rectified and implemented: 1. Every office is equipped with fire extinguishers and gas masks.

2. The obstacles in the fire escape have been cleared, and there are no obstacles around the fire hydrant 1 m, which ensures the normal use of fire fighting equipment without obstacles.

There is a sign of "No Smoking" in the meeting room.

Second, the rectification measures:

In order to ensure safety and eliminate fire hazards, the company made the following rectification in view of the main problems existing in the inspection and self-inspection process of the superior security department:

1. Strengthen publicity and raise awareness.

2. The company educates employees on safety knowledge, fire laws and regulations, public security and comprehensive management of safety work. Through these forms of publicity, employees are fully aware of the importance of creating a safe and civilized life, and the responsibility of "putting prevention first and combining prevention with elimination" is more important than Taishan consciousness.

3. The company attaches importance to the formation of employees' behavior habits, and puts the responsibility of "three clean-ups and three customs" on people, so that the safety inspection management can be implemented on people. By paying attention to the management of * * *, we can make regular and frequent inspections, and some people will be arrested and managed, so as to promote the full implementation of safety management and ensure the safety of property and life.

3. Self-inspection report on safety hazards of fire extinguishers

According to the requirements of safety work, we always attach great importance to safety work, and now we report the inspection situation in the first half of the year as follows. This inspection involves seven items of information: 1. Fire prevention publicity and training.

Always put safety first in work and organize employees to conduct a safety education; Hang warning signs in canteens, corridors, kitchens and other places where fire and electricity are used to remind the importance of safety at all times; For new temporary workers and employees, the use of fire extinguishers and the fire alarm process are explained. Demonstrated the use of fire extinguishers.

Second, the fire facilities and equipment

The fire extinguisher was inspected this time, and other facilities were managed by the property.

Third, the use of electrical appliances.

This inspection made a detailed inspection of the hygiene and operating conditions of the operating room. Sanitary conditions are good, and common equipment such as rice cookers are used normally to ensure that there is no fire caused by operational errors.

Four, power distribution, circuits and lines

Check data: operation status of distribution box, operation room, warehouse facilities and equipment and simple lines. After inspection, the distribution box and facilities and equipment are operating normally, and there is no problem of unauthorized wiring. Establish relevant inspection systems, implement responsibilities, and effectively eliminate potential safety hazards.

Verb (abbreviation for verb) fire escape

The fire escape in the canteen is unblocked and there is no debris piled up; Clean it once a week, with good sanitation; Lighting and channel identification are in good condition and meet safety requirements.

Six, shopping mall cargo channel inspection, found that there are not enough fire extinguishers, added four.

Two emergency lights were added, and the electricity was stable in two places.

Seven, whether there is a fire hazard

1. The wires and circuits in the canteen wall are damaged to some extent.

2. Some employees are still lucky and will strengthen continuing education in the future.

We found a place with stable electricity consumption and made changes.

4. The shopping mall found two stable places and made changes.

Through this self-examination, some hidden dangers of fire safety in our department were eliminated as far as possible, and employees were given an education lesson ideologically and consciously, which improved their knowledge and skills of fire safety and laid a solid foundation for the safety system of employees' canteens.

4. Fire extinguisher safety hazard inspection report

In order to ensure the fire safety and anti-theft safety of the office environment in our center, on March 22-23, according to the arrangement of the leaders of the center, the person in charge of the center led the office and logistics personnel to form a safety inspection team, and conducted a strict inspection on the fire safety and anti-theft work of the office building and the experimental building of the center. The inspection situation is now reported as follows: 1. General situation of safety inspection.

The inspection team first inspected the doors and windows, computer room and office equipment on the third and fourth floors of the office building, the power circuit and switch of the canteen on the first floor, the fire safety passage in the corridor, fire-fighting facilities, electricity and water consumption and environmental sanitation. Then, the cold storage on the first floor, offices on the second to fourth floors, doors and windows, instruments and equipment, office equipment, power lines, fire safety passages in corridors and fire-fighting facilities of the laboratory building were inspected. Through comprehensive and thorough investigation, the inspection team left no dead ends, and the overall inspection results were in good condition, with no major safety hazards.

Second, the existing problems

1, each floor has been equipped with 8 kg and 4 kg dry powder fire extinguishers directly placed on the ground, which is not conducive to the storage and maintenance of fire-fighting equipment.

2. Some office and laboratory power sockets and plug boards are damaged, which has potential safety hazards.

3. sundries are piled up in the computer room, which is messy and has fire safety hazards.

4. There is no security door in the experimental area of the experimental building, and outsiders can enter and exit at will, which is a potential safety hazard.

Third, the rectification measures and suggestions

1. Buy a special box for fire-fighting equipment, install all fire extinguishers, effectively protect fire-fighting equipment and pile it up neatly.

2. Require the logistics department to replace the defective power socket in time, and the office plug-in board shall be replaced by the user to ensure the safety of the electrical appliances (instruments) used.

3. It is forbidden to pile up sundries in the machine room and clean them up immediately to eliminate fire safety hazards and ensure the normal operation of the machine.

4. Install anti-theft safety door at the entrance of the second floor of the experimental building to ensure the property and fire safety of the office and instruments and equipment of the experimental building.

5, adhere to the normalization of fire safety, long-term grasp, it is recommended to set up a central fire safety work leading group, strengthen safety publicity and education, establish and improve safety management rules and regulations, adhere to the monthly supervision and inspection of fire safety work, and investigate potential safety hazards.

In view of the hidden dangers of fire safety and the self-inspection of fire safety found in the inspection, the person in charge of the center pointed out that the hidden dangers of fire safety are related to the life safety of all cadres and workers and the safety of state property. Everyone should fully realize that the responsibility of fire safety is great, and we should not be slack and lucky, ensure that "fire safety does not leave a dead end", eliminate potential safety hazards, and create a stable and safe working and living environment.

5. Self-inspection report on safety hazards of fire extinguishers

"Pay attention to safety and ensure safety" is an important work that our club has been insisting on for a long time. In order to ensure the safety of all employees, we firmly established the concept that safety is the first and responsibility is more important than Mount Tai. Since the club opened in September, 20xx, it has participated in the training of the national government and relevant departments for many times, conscientiously implemented the principle of "unified leadership by the government, supervision by the departments and overall responsibility by the units", so as to ensure that everyone is responsible for fire prevention, improve the safety awareness of all staff and nip in the bud. According to the information of fire organization training, we returned to the club for a substantial fire safety "fire drill" and "fire safety knowledge" training. This time, according to the document requirements and deployment, the association organized relevant personnel to conduct a serious fire safety self-inspection, and the situation is now notified as follows:

A, check whether the safe passage is clear:

At present, there are three exits, and there are no sundries at the exits of corridors, two-way stairs and staff passages in the building to ensure the smooth flow of fire exits; The aisles and exits leading to the outside of the building are equipped with "exit signs" and "emergency lighting"

Second, check the evacuation emergency facilities and fire equipment:

1. The clubhouse building is equipped with 15 "emergency light" and 17 "exit sign", which can be used normally to ensure emergency lighting and indicate the exit direction in case of power failure.

2. Nine fire hydrants have been installed, all of which can be used normally. The club also organized personnel to conduct a comprehensive understanding and practical operation drills on fire hydrants.

3. Fire extinguisher. The fire extinguishers used in this club are all "dry powder" fire extinguishers, totaling 30. In this self-inspection, all the existing 30 fire extinguishers are within the validity period.

4. There are always * * * fire doors, which were not closed in place when the fire brigade came to check in the early stage. After later rectification, all fire doors have been closed in place.

5. The spraying and smoke prevention systems are working normally, and the fire alarm controller also shows "alarm system is normal".

6. The fire pool, spray pipe, fire hydrant pipe, switch and valve are all intact.

7. All loop pipelines are completed in the form of pipeline penetration.

Third, check the common sense of fire fighting:

On the basis of the original fire knowledge, the fire knowledge of employees in charge of warehouses and private rooms is randomly selected, and how all employees evacuate people and save themselves in case of fire is randomly selected.