What should I pay attention to when I hand in the blank and get the key?

● Check the facade, exterior wall tiles and paint, unit doors and corridors.

2. Then check the inside.

● Check the entrance doors, doors, windows, ceilings, walls, floors, wall tiles, water supply and drainage, waterproof and water storage, strong and weak electricity, heating, gas, ventilation, smoke exhaust and exhaust one by one.

3. Finally measure the adjacency.

● Problems such as closed water test and water meter idling must be coordinated with neighbors upstairs and downstairs.

Second, the details of the house inspection when the blank house is closed.

1, check the water and electricity

(1) First, check whether the reading of the water and electricity meter is normal. If there is too large a number, it must be handled in time.

(2) When testing the circuit, general home improvement will involve strong and weak current boxes, depending on whether the installation of the strong and weak current boxes meets the national standards and whether the distance is above 1 m, otherwise it will easily cause signal interference.

(3) check the waterway, pay attention to whether the waterway is unobstructed. Specifically, you can pick up a bucket of water and pour it into each floor drain to see if the drainage is blocked. This must be carefully checked, otherwise it will seriously affect your daily life in the future.

Step 2 check the doors and windows

Check the doors and windows, first of all, whether there is a "CCC" sign on the window glass, check whether the sealing strips of doors and windows are intact, whether the glass is broken, whether the switch is smooth and other details.

3, check the wall flatness

Use the guiding rule to cling to the wall and check the flatness of the wall. Generally speaking, it is reasonable to consider the gap within 0.5 cm. In addition, pay attention to the vertical angle of yin and yang in the room.

4, check the founder of the room

This is relatively simple. You can simply measure the diagonal lines of the four corners of the room with a tape measure. Generally, the length error of two diagonal lines is within 5 cm.

5, check the wall empty drum

Check all the walls with an empty drum hammer, and pay attention to the fact that there cannot be more than two empty drums in a room. At the same time, it is necessary to check the floor that needs to be laid with tiles, so as to repair it in time before the decoration construction.