Job Recruitment Website - Property management - How to detect water leakage in houses? How to repair the leaking house?

How to detect water leakage in houses? How to repair the leaking house?

If the house leaks water, it's really a bad thing. I feel very troublesome. I don't even know where the water leaks, and I don't even know how to detect the water leakage in the house. The house is detected, how to repair it? Don't worry, I'll tell you how to solve these problems in detail! If the house leaks water, it's really a bad thing. I feel very troublesome. I don't even know where the water leaks, and I don't even know how to detect the water leakage in the house. The house is detected, how to repair it? Don't worry, I'll tell you how to solve these problems in detail!

How to detect water leakage in houses?

1. Thin plates shall be used to protect the suspected leakage parts such as parapets. This method is suitable for small special parts, such as the facade of the roof. It needs to be observed for a long time and covered with a waterproof sheet of a certain size. Use the method of sprinkling water around or observing after rain to judge whether there is leakage in this part.

2. Water storage method: Sprinkle water or store water at the suspected leakage part to judge whether there is leakage. This method is simple and easy to operate, and it is a traditional detection method commonly used in waterproof engineering construction acceptance, but it takes a long time, and the detection site and area are limited, which requires the inspectors to have professional knowledge and practical experience.

How to repair the leaking house?

1, external wall leaks. Then we must find a property to solve it, because it is very troublesome to repair the leakage of the external wall.

2. If the water pipe leaks, it is necessary to find out where the water pipe is broken, find out the direction of the water pipe by comparison, then find out the degree of water leakage, find out the completion drawing of the original water and electricity laying, dismantle a small range of floor tiles, then repair the water pipe again and carry out the water pressure test. If there is no problem, you can tile it again. (Note that there are extra floor tiles. If there is no suggestion to make them bigger, only one or two repairs will be ugly. )

3, bathroom, kitchen, balcony leakage, that is, waterproof is not done well, and then stick a brick, stick a brick as carefully as possible, and then remove the floor tile or bathroom caisson, re-level to make waterproof, do not scrape off the waterproof layer. There is also the need to pay attention to the waterproof interface position between the ground and the wall, and try to brush it up, not just the ground.

After reading my two questions about how to detect and repair the house leakage, do you think it is not so difficult to repair the house leakage? As long as the method is right, it can actually be easily repaired, and it is also a relatively fast detection reason, so that you no longer worry, I hope to help you!