Who is responsible for not heating?

It should be the responsibility of the property company.

Legal analysis

If the flow rate is far below the minimum flow rate to ensure accuracy, there will be no output (such as vortex flowmeter) or the output signal will be cut off as a small signal (such as differential pressure flowmeter), which is unfavorable and unfair to suppliers. In order to prevent the loss of benefits, for a specific set of thermal energy metering equipment, the supply and demand sides often agree that a certain flow value is the "agreed lower limit flow" according to the flow measurement range and the achievable range, and agree that if the actual flow is less than the agreed value, it will be charged according to the lower limit flow. The metrological administrative department of the people's government at or above the county level may set up metrological verification institutions according to needs, or authorize metrological verification institutions of other units to perform compulsory verification and other verification and testing tasks. Personnel who perform the verification and testing tasks specified in the preceding paragraph must pass the examination. This function is usually realized in the flow display instrument. The metrological administrative department of the local people's government at or above the county level shall, according to the needs of the local area, establish public standard instruments of measurement, which shall be used after passing the examination presided over by the metrological administrative department of the people's government at a higher level. Enterprises and institutions may, as required, establish standards of measurement for their own use, and the highest standards of measurement shall be used after passing the examination presided over by the metrological administrative department of the relevant people's government. Metrological verification shall be carried out on site in accordance with the principle of economy and rationality. Metrological verification must be carried out in accordance with the national metrological verification system table. The national metrological verification system table shall be formulated by the metrological administrative department of the State Council.

legal ground

"Xinxiang city central heating management measures"

Twenty-third users indoor heating temperature is 65438 08℃ 2℃, and shall not be lower than 65438 06℃. Heating enterprises shall, in accordance with the relevant provisions of the state, set indoor temperature detection points for residents' heat users and regularly detect indoor temperature.

Twenty-fourth: heating enterprises should establish and improve the heating emergency repair system and emergency plan for accident handling. Strengthen the management of standardized services, make the standards, contents and time of standardized services public and accept the supervision of users. Set the telephone number for repair and complaint, and deal with the problems reflected by users in time. The competent heating department shall supervise and inspect the service quality and heating quality.