How to adjust the elevator hall door if it is not closed properly?

How to adjust the elevator hall door if it is not closed properly?

Pay attention to safety when taking the elevator. The elevator door is not closed properly. How to adjust it?

First, how to adjust the elevator hall door if it is not closed properly?

In case of this problem, first of all, it is necessary to check whether there are obstacles in the armor of the hall door, which leads to the door not being closed and not being closed well. One of them has a heavy hammer or spring because of friction, which will lead to the problem of not closing the door tightly when opening and closing. The device that can adjust the linkage of door locks needs professional operation.

First, remove sundries, dust, etc. It should be deleted in the lobby and then sanded. Remember to polish the pulley device at the same time to reduce friction. Add a small amount of lubricating oil, and then remove the guide shoes under the door to see if they are parallel. Align both ends with a wrench, and then install the guide shoes. In addition, the tightness of the wire rope should be adjusted. When the door is fully open, press the wire rope down 2~3 cm, not too tight, otherwise it will be easy to wear.

Second, the elevator door won't close. What happened?

1, when we take the elevator, we may encounter the problem of not closing it. Is there something wrong with the elevator? It is possible that the motor power of the elevator is relatively small. If it is pressed by the wind, the resistance will increase and the motor belt will not move, resulting in the door not being closed. Or it will stay on a certain floor and never get up again and again.

You must pay attention to this problem. Don't take the elevator. You can explain the specific situation to the property company or the person in charge of the residential building in time.

3. If it cannot be closed after adjustment, it is necessary to consider that there may be a problem with the light curtain. It is necessary to check whether the light curtain of the motor can be used normally, or it may be that the controller is abnormal and cannot be turned off.