Job Recruitment Website - Property management - What should be included in the investigation of potential safety hazards in the property management area?

What should be included in the investigation of potential safety hazards in the property management area?

Property company * * * regional security risks investigation should include the following contents:

1. The service center should do a good job in fire prevention in spring, and conduct a comprehensive inspection of fire-fighting facilities, including alarms: check whether the alarms in various areas and concentrated areas are working normally.

2. Thoroughly check the water system in the community, including (1) checking whether the pumps, pipes, lighting facilities and lines in the water system are in good condition and available; (2) Hygienic conditions meet the water supply standards.

3. Maintenance of power supply and distribution system, including: comprehensive dust removal and rust removal; Check that the grounding is good, the cable terminal and screws are fastened, and handle them in time if they are loose; When power distribution is overhauled, warning signs should be hung on the workplace, once-closing switches and knives, and the fuses should be disconnected.

4. Maintain the lightning protection system, including checking whether the lightning rod, lightning rod, down lead and down lead are rusted, and derusting and painting with silver paint in time if any. If the corrosion degree is serious, and the section corrosion reaches more than 30%, it must be replaced; Tap the conductive contact part of the down lead with a small hammer to check whether the contact is good and whether the solder joint is desoldering. Solve problems in time. More exciting plus property community WeChat; Check whether the grounding wire and grounding device are normal, whether the grounding nut is firm and reliable, and correct and tighten it in time when problems are found; Use grounding resistance meter to test the grounding resistance of lightning protection system, which is less than10Ω.

5. Clean up the garbage, including the garbage in the management area, to avoid fire caused by accumulation; Make a plan for stacking items and clean up the system.