The garage door remote control can't open and close the door, the indicator light is still on, and the receiver only sets the button to open and close the door. How to set it up?

The motor needs to be coded by the remote control key.

1. First, prepare the buttons of the motor controller and remote controller to be aligned. As shown in the figure

2. There are two buckles in the lower right corner of the faucet, which can be used to open the motor controller. As shown in the figure

3. Buckle your hands at the same time and lift them at the same time to open the motor remote control cover. As shown in the figure

4. The board motor controller is a code switch. As shown in the figure

5. Press and hold the up door button on the remote control to complete the code alignment. As shown in the figure

6. Press and hold the down key of the remote controller until the light of the motor controller turns green, and then you can add the remote controller. As shown in the figure

Extended data:

(1) Travel setting method:

Press and hold the setting key for three seconds and then let go, then press and hold the add key to open the door to the upper limit position, then press and hold the setting key for about three seconds and let go, then close the door to the lower limit position, and let go after three seconds to save the trip.

(2) Code remote control method:

Press and hold the "code-checking key" on the control panel of the motor housing (or motor internal circuit board) for 2-3 seconds, and let go immediately after the "code-checking light" lights up. After holding our remote controller for 4-5 times continuously, the "code alignment key" flashes, and the code alignment is successful at the end of flashing.