Can the entrance door of commercial housing be moved?

You can consult the property in this community. Generally speaking, the entrance door cannot be changed. The wall occupied by the entrance door is too big. If it is adjusted, it may affect the main structure of the house and endanger the safety of the building. The property will not agree. However, you can usually make some minor adjustments on the original door frame. If the adjustment is not big, the impact is not big, but you should also consult the property.

How is the entrance door installed?

1. Before installing the door frame, you need to buy a suitable entrance door according to the size of your own door opening. When installing the door frame, fix the side frame first, and drill countersunk holes to fix the expansion screws, which is beneficial to the later fixing of the top frame and the side frame. Then put temporary fixed wooden boards under the door frame to assist in correction.

2. After the door frame is installed, it is necessary to install the door opening, put the assembled door frame into the door opening, adjust the position, and then tighten the door frame with a wooden wedge. If there is a gap between the wall and the door frame, it can be filled with glue or cement slurry, and then the temporarily fixed wood square and the redundant wedge can be removed.

3. Finally, just install the door leaf. First, put the frame line of the door cover into the wall hole, so that the joint angle between the edge of the door frame and the top of the door frame is 45 degrees, and the two sides of the door frame are parallel and perpendicular to the top of the door frame. Mark the position of the door leaf and reserve a certain gap, then you can fix the door leaf in the corresponding position and adjust it to the exact position.

Size of entrance door

Standard size of villa gate.

The general villa will have two doors, one is the courtyard door and the other is the entrance door; The width of the courtyard gate is generally about 2.5 meters, at least allowing vehicles to enter and exit; Of course, the width of the courtyard gate of the villa depends on the housing area and building structure. For some large courtyards, the width of the villa gate can reach 3 meters or 4 meters. The height is not limited. At present, there are two commonly used sizes of villa entrance doors, 1.2m * 2.5m and 1.5 * 3m.

Standard area of ordinary residence.

The entrance door of a general house adopts a sub-door, the size of which is 1200×2000. Unit door width is not less than 2000, height is not less than 2200. Generally, the size of the entrance door with courtyard in rural areas is 1.5m or1.8m. Their main consideration is that finished doors can be bought in the market according to this specification, and non-standard doors are troublesome to make. However, if parking in the hospital is considered, it should be calculated according to the width of your own car, but at least 2.1m.

Standard size of entrance door of commercial housing.

Single door 1.2- 1.5M wide and double door 1.8, 2M wide, needless to say; Country bungalow, 2800 mm high and 2600 mm wide. As for the entrance door of commercial housing, the mother door can be considered, which is 2050MM high and 1260MM wide. The doors from 1 m to 1.5 are double doors.