Job Recruitment Website - Property management - How to deal with water leakage after tiling the roof?

How to deal with water leakage after tiling the roof?

1. If the water leakage is not serious, you can use a special transparent waterproof glue and apply it to the tile for waterproofing.

2. If the water leakage is very serious, it is recommended to find a residential property or construction personnel to pry open the floor to do waterproof work again.

What if the roof leaks? 1. If the roof leaks, we need to find all the leaking points first. Usually, it is necessary to find leakage from high to low, check whether there are cracks in the roof, see whether the waterproof layer of the roof is aging, whether it has waterproof effect, and whether there are bubbles in the waterproof film. If there are a lot of bubbles in the membrane, it means that the waterproof layer on the roof surface has been flooded and the water leakage is quite serious. In addition, we need to check whether the gutter is blocked. If the tile house in the countryside leaks, only the tiles need to be replaced.

2. If the roof leaks in a large area or in many places, you can ask special maintenance personnel to check whether there are cracks on the roof. After the cracks are treated, you can spread the corresponding waterproofing membrane on the roof. If the owner is not sure about the waterproof effect of his home, he can put insulation board on the roof. Usually, the thickness of insulation board can reach more than 20cm, so insulation board not only has excellent waterproof effect, but also has certain insulation effect.

3. If there is water leakage on the wall except the roof, then the professional construction personnel will use the hanging basket. If there is a big crack in the wall, you can use the plugging king to repair it. If the crack is small, it can be repaired with glass glue. In addition, the roof leakage repair needs to be carried out under the dry roof to avoid the failure of waterproof engineering.

If the owner's house has not been waterproof before, it is necessary to remove the leaking part of the roof by about 3 cm, then clean it, and finally water it with asphalt. If the waterproof layer of the house is troublesome, it is necessary to tear down the surrounding waterproof layer and make a new one. When doing it again, it should be noted that the place where it meets the original waterproof layer needs to be strengthened.

In addition to our common bungalows and buildings, there is also a kind of covered red tile building, which is also often built in urban areas. If this kind of house also has the problem of roof leakage, we need to remove grass or moss from the tiles or replace the tiles.