What should I do if the middle of the double glass is dirty?

Raw materials: flat screwdriver, double glass.

Steps:

1, remove the glass with water vapor from the plastic steel doors and windows with a screwdriver, and lay the glass flat on the ground.

2, wallpaper knife along the upper glass, glass points open on the side, and then use wallpaper knife to tear off the tape on the lower glass.

3. Clean the adhesive tape residue with a knife print, clean the front and back of two pieces of glass with cloth or other things, and lay them flat on the ground or workbench.

4. Clean a piece of glass and stick it along the four sides of the glass with double-sided adhesive tape to achieve the sealing effect without leaving gaps.

5. Then use double-sided tape to fasten another piece of glass to the glass. Press gently along the four sides of the glass to prevent water from entering again and generating steam.

6. After that, put the pressed glass on the plastic doors and windows, and smash the layering with a small hammer.