What is a good way to flush the toilet? What should I do if the toilet is always flooded?

As we all know, it's troublesome that the toilet is broken. For example, the toilet is always filled with water, which is a big trouble. Next, tell me the solution!

The flushing mode of the toilet is 1, and the flush toilet uses the impulse of the water flow to discharge dirt. Generally, the pool wall is steep, and the water storage area is small, so that the hydraulic power is concentrated, and the descending hydraulic power around the toilet seat increases, and the flushing efficiency is high. With the help of the huge thrust formed by compressed air, the washing speed is fast, the impulse is large, the sewage discharge is fast, the speed is fast, the water consumption is small and there is no leakage.

2. Siphon Siphon toilet has a "∽"-shaped drain pipe, which will produce a certain water level difference after being filled with water, and the toilet will be discharged through the suction generated by washing water in the sewage pipe in the toilet. Because the flushing of siphon toilet depends on the impulse of water flow, the water level in the pool is large and the flushing noise is small.

3. Vortex siphon The flushing port of this toilet is located at one side of the bottom of the toilet. When flushing, the water flow forms a vortex along the pool wall, which will increase the scouring force of the water flow on the pool wall and increase the suction of siphon effect, which is more conducive to the discharge of the internal organs of the toilet.

4. Jet siphon is a further improvement of siphon toilet. An auxiliary jet channel is added at the bottom of the toilet, aiming at the center of the sewage outlet. When flushing, part of the water flows out from the water distribution hole around the toilet seat, and part of it is sprayed out from the spray port. This toilet seat is based on the siphon principle, which uses a large water impulse to quickly wash away dirt.

What should I do if the toilet is always flooded? 1. First of all, we can check whether its flush switch is restored, because some toilet flush switches are easy to wear or get stuck after being used for a long time and cannot be restored. Generally speaking, the switch can be reset after several repetitions.

We can check the water level limiter of the lower water tank to see if it is loose or too high. If it is too high, the water in the water tank will exceed the overflow level and flow into the toilet from the overflow pipe.

3. We can also check whether the outlet of the lower water tank is blocked. If the plug of its water outlet is worn or something blocks it, resulting in the plug not being tightly blocked, it will also cause the toilet to run.

4. If the problem is serious or we can't solve it ourselves, then we can invite professional maintenance personnel or contact the property management of your community for maintenance.

Common faults of toilet and their solutions 1. The toilet leaks 1, and the toilet water tank leaks. Generally, we first open the lid of the water tank and observe where the water ladle is when the water in the water tank is full. If the water in the water tank is full and water keeps entering the water tank, then the water tank will definitely leak. At this time, the fault appeared on the ladle. The water scoop can be replaced or repaired, and then it is best to lower the water scoop.

2. If there is something wrong with the water spoon, check the outside of the water tank. There is a stainless steel hose connector outside the water tank, which is where the water in the water tank enters the water tank. Check whether the water pipe is damaged or not tightened. Then carry out targeted maintenance.

3. In addition to the above two possibilities, it is also possible that the water tank is damaged by external impact, resulting in water leakage. When this problem occurs, it is necessary to repair the water tank. When repairing cracks, you can use some special glue to repair the water tank, but this method can only repair minor cracks. The crack is too big, so only professionals can repair or replace it.

Second, the water tank does not enter 1, and the toilet tank does not enter water. Maybe the tap water pressure is not high enough.

2. At the same time, check whether the filter screen outside the water inlet valve is blocked by filtered debris. If there is, remove the sundries. Remember to clean the filter regularly in the future

3. In addition, check whether the sealing ring inside the valve body of the water valve falls off or there are impurities such as sediment. If the sealing ring falls off, it can be reinstalled to remove impurities.

Cleaning points and precautions of toilet 1. Try not to set a wastebasket next to the toilet. At ordinary times, you can also put a gradually dissolving automatic toilet cleaner in the water tank or hang a wall-mounted disinfection plug, so as to achieve the effects of cleaning, descaling, disinfection and sterilization by flushing each time.

Most families will set a wastebasket next to the toilet to store used toilet paper, but this will cause bacteria to spread with the air, because few people can clean it at any time, at least for a day or two, and the longer it takes, the more bacteria there will be.

Toilet paper should be thrown into the toilet and washed away. As long as it is not too thick and tough, toilet paper can generally soften quickly in water, so don't worry about clogging. When necessary, just prepare a sanitary bag, there is no need to set up a waste paper basket. If you must use it, you should also choose a cover to prevent the spread of bacteria and dispose of used toilet paper in time.

2. There are many bacteria in the toilet seat, so it is very important to clean 32% toilets with Shigella dysenteriae. One strain of Shigella dysenteriae named "Songnei" survived on the toilet seat for 17 days. Another experimental report also pointed out that 654.38 billion polio viruses were thrown into the toilet, and 3,000 viruses spilled on the toilet seat. At the same time, many people like to put a flannel pad on the toilet in winter, which makes it easier to absorb, retain and excrete pollutants and spread diseases more easily.

The place with such serious pollution is the place with the closest contact with human skin, which needs to be cleaned emphatically and wiped with diluted household disinfectant every one or two days. As for the cloth gasket, it is best not to use it. If you must use it, you should always clean and disinfect it. If you have the conditions, you might as well change to a toilet with antibacterial function and splash-proof design.

3, toilet flushing habits-cover the toilet lid Dr. Philip Terno of new york University pointed out that if the toilet lid is opened during flushing, the instantaneous cyclone in the toilet can bring germs or microorganisms into the air up to 6 meters, and make them suspend in the air for several hours, and then land on walls and objects. At present, most families go to the toilet, wash and shower in the bathroom. Toothbrush, mouthwash cup, towel and toilet are in the same room, so they are naturally susceptible to bacterial contamination. Therefore, it is necessary to develop the habit of covering the toilet lid when flushing.

4. Clean up the dirt in the toilet in time. Toilets are easily polluted by urine stains, feces and other dirt. If you find that there are still traces after flushing, you must clean it with a toilet brush in time, otherwise it will easily form macular spots and breed mold and bacteria. In addition to being close to the nozzle, the water outlet at the inner edge of the toilet and the outer side of the base are places where dirt is hidden. When cleaning, first lift the toilet seat and spray it with toilet cleaner. After a few minutes, brush it thoroughly with a toilet brush, preferably with a fine brush, so as to better clean the depth of the inner edge of the toilet and the nozzle. Then scrub the base and other gaps.

5. The toilet brush should be kept clean and dry. Toilet brush is the hero to keep the toilet clean. But if you don't pay attention to cleaning and drying, it will also become a source of pollution. Every time you brush something dirty, you will inevitably get dirty on the brush. It is best to rinse with clean water, drain, spray with disinfectant, or soak with disinfectant regularly and put it in a suitable place.

It is suggested that the toilet brush should be hung up, and it should not be placed in the corner or closed container casually.