Job Recruitment Website - Property management company - Safe operation of property elevator?

Safe operation of property elevator?

1, what should be done before the elevator runs:

1. 1 Before opening the hall door and entering the car, you must confirm that the car is parked on this floor before entering the car.

1.2 Turn on the lights and fans in the car.

1.3 Drive the elevator up and down once to check whether the operation is normal.

2, when the elevator is running, should do:

2. 1 Prevent the elevator from being overloaded and overloaded, and always pay attention to the overload protection function of the elevator.

2.2 Passenger elevators are strictly prohibited from carrying goods.

2.3 It is forbidden to ship inflammable, explosive, corrosive and toxic dangerous goods. In case of special circumstances, it must be approved by the management office and take necessary safety protection measures;

2.4 It is strictly forbidden to open the safety window of the car roof and transport super-long objects;

2.5 passengers are not allowed to lean on the door and hall door;

2.6 The car roof shall be kept clean, and other sundries shall not be piled up;

2.7 sudden change of direction is not allowed when driving, and it must be started after the elevator stops;

2.8 The goods should be placed in the middle of the carriage as smoothly as possible, so as to avoid dumping and damaging the carriage during operation;

2.9 In case of sudden power failure during operation, passengers are advised not to panic and take safety rescue measures to properly handle it;

2. 10 When the elevator stops, stop the car at the grass-roots level, turn off the lights and fans, and then turn off the key switch at the grass-roots level.

3, the following fault should immediately press "alarm" or call the personnel on duty.

3. 1 The hall door and car door are closed, but the elevator can't start normally.

3.2 The running speed has obviously changed.

3.3 The driving direction is opposite to the instruction direction.

3.4 Internal selection, leveling, speed change, elevator call and finger signal failure and out of control.

3.5 There is abnormal noise, large vibration and impact.

3.6 Beyond the terminal location and continue to operate.

3.7 misoperation of safety tongs.

3.8 Contact with any metal parts in the car is hemp.

3.9 When the electrical part is overheated, it will give off a burning smell.

4, maintenance personnel in the machine room with the handwheel rotation, make the elevator car for short-distance lifting, must first cut off the main power switch, two people cooperate well.

For more information about project/service/procurement bidding, and to improve the winning rate, please click on the bottom of official website Customer Service for free consultation:/#/? source=bdzd