Legal provisions on dumping garbage in residential buildings

Construction waste stacking regulations:

1, generally on the first floor of the house, a less conspicuous corner;

2. Choose a location that does not affect the beauty of the community, and choose a location that is convenient for garbage removal and cleaning;

3. It is generally stipulated that garbage should be piled up in a semi-closed or closed position to avoid affecting the beauty of the community;

4, construction waste piled up to clear in time, piled up no more than a week.

Construction waste refers to muck, waste concrete, waste masonry and other wastes produced by people in production activities such as demolition, construction, decoration and repair. According to the source classification, construction waste can be divided into engineering muck, decoration waste, demolition waste, engineering mud and so on. According to the composition classification, construction waste can be divided into muck, concrete block, gravel block, brick fragment, waste mortar, mud, asphalt block, waste plastic, waste metal, waste bamboo and wood, etc.

The garbage room in residential area should be more than 10 meter away from the main building. The garbage station should be located in the downwind and shelter of the house (community), with an area of not less than 6_, a distance of not less than 10m from the house, and the outside is connected with the road; The ground and inner wall of the garbage station should be pasted with flat and clean materials, and equipped with water supply and drainage facilities. At present, there are no specific laws and regulations on the dumping places of residential buildings, which are generally set by local regulations, which set residents to register with community neighborhood committees or property service enterprises and put them in designated places. The main provisions are as follows: (1) The Regulations on the Management of Decoration Waste in Residential Areas stipulates that the removal and relocation of non-bearing walls must be approved by professionals before implementation; New partition walls must be made of light materials, and red bricks shall not be used for masonry except for special requirements. The pipe diameter is greater than 1.2 cm, and it is not allowed to be concealed in the load-bearing wall, and it is not allowed to expand the original reserved holes of the range hood and exhaust fan; The selection and pulling should not affect the beauty of the park, so it is necessary to choose a secondary location to facilitate hanging upside down and transportation.

Legal basis: Article 10 of the Standardization Law of People's Republic of China (PRC) formulates mandatory national standards for technical requirements to protect personal health and life and property safety, national security, ecological environment safety and meet the basic needs of economic and social management. The relevant administrative departments in the State Council are responsible for proposing, organizing drafting, soliciting opinions and technical review of mandatory national standards in accordance with their duties. The State Council standardization administrative department is responsible for the formulation, numbering and external notification of mandatory national standards. The administrative department in charge of standardization in the State Council shall examine whether the mandatory national standards to be formulated conform to the provisions of the preceding paragraph, and establish a project if they conform to the provisions of the preceding paragraph. The administrative departments of standardization of the people's governments of provinces, autonomous regions and municipalities directly under the Central Government may put forward suggestions to the administrative departments of standardization of the State Council to formulate mandatory national standards, which shall be decided by the administrative departments of standardization of the State Council jointly with the relevant administrative departments of the State Council. Social organizations, enterprises, institutions and citizens may put forward suggestions to the administrative department in charge of standardization in the State Council to formulate mandatory national standards. If the standardization administrative department of the State Council considers it necessary to establish a project, it shall decide with the relevant administrative departments of the State Council. Mandatory national standards are issued with the approval or authorization of the State Council. Where laws, administrative regulations and the State Council decisions provide otherwise for the formulation of mandatory standards, such provisions shall prevail. Eleventh basic and universal technical requirements, which are compatible with mandatory national standards and play a leading role in related industries, can formulate recommended national standards. Recommended national standards shall be formulated by the administrative department of standardization of the State Council.