Maintenance of monitoring probe

Many people go out, and sometimes their homes are stolen and their property is lost. Traveling abroad is a very happy thing When I got home, I found that my home was stolen, and my mood fell directly to the bottom. So many people or shops will install monitoring probes at the door. At every traffic intersection, we can also see surveillance cameras shooting illegal vehicles. Monitoring probes can be seen everywhere, but it is easy to get dust on the roadside, which affects the clarity of the shooting picture. Let us show you how to maintain the monitoring probe in Bian Xiao.

Pay attention to several aspects when maintaining:

Attention should be paid to the installation position of monitoring probe.

Do not install the monitoring probe near the air outlet of the air conditioner. The rapid temperature change caused by the switch of the air conditioner easily leads to fog on the lens of the monitoring probe. Don't put it near equipment that generates heat, such as heat, and don't use the camera when it exceeds the temperature, humidity or power supply specifications.

Secondly, when using the network monitoring probe, do not disassemble the monitoring probe without authorization, and do not disassemble the monitoring probe at will unless necessary. If there is any fault, you should directly contact qualified maintenance personnel or send the monitoring probe directly to the maintenance department for maintenance. Third, after installing the monitoring probe, don't tamper with the monitoring probe to avoid being hit or shaken. Avoid contact between the monitoring probe and oil, steam, water vapor, moisture, dust and other substances, avoid direct contact with water, and do not pull or wind the connecting wire to avoid damaging the monitoring probe.

Check regularly.

According to the operating instructions of each part of the monitoring system, the technical parameters and transmission line quality of the monitoring system are generally tested every month, and the aging monitoring equipment parts are replaced and repaired in time, and hidden dangers such as signal connectors and cooling fans of hard disk video recorders are dealt with to ensure that all parts of the equipment function well and can operate normally.

Dust removal is carried out regularly.

Generally, the equipment is dusted and cleaned once every quarter in order to remove the dust exposed by the monitoring equipment. The general steps are: remove the monitoring probe, protective cover and other components to completely blow off dust, and then clean each lens with anhydrous alcohol cotton to adjust the definition, so as to prevent dust from being sucked into the monitoring equipment body due to factors such as machine operation and static electricity, and ensure the normal operation of the machine. At the same time, check the ventilation, heat dissipation, dust removal and power supply facilities in the monitoring room. Outdoor temperature, indoor temperature and relative humidity should be within the specified range, so as to ensure a good operating environment for monitoring equipment.

Installing a monitoring probe is not expensive, but it can ensure safety. Through a lot of news, we can know the importance of monitoring probes, and the police can detect murders and thefts through monitoring probes. Even some criminals who kidnap children. A small monitoring probe, a big role, installed at home, maybe when it will play a big role. Although no one wants their home to be stolen, accidents will still happen, so we should nip in the bud and avoid avoidable losses.