What are the precautions for hydropower positioning?

The positioning of hydropower in home decoration is an important step. This is closely related to the use of electrical appliances and sockets and the installation of sanitary ware and gas appliance. Therefore, we must fully consider the future layout and do a good job in hydropower planning and positioning. What preventive measures are there for hydropower positioning? Bian Xiao Bunny? Noodles make everyone understand.

What are the precautions for hydropower positioning?

Preventive measures for hydropower positioning:

1。 Prepare marks and tape measure before positioning. Usually electricians carry them with them, but it should be just in case. After positioning with the electrician, be sure to check it again at the scene, and pay attention to the location of each electrical appliance, such as air conditioning.

2. Hydropower positioning is to determine the position of the switch socket and waterway interface of the whole house according to your needs. The plumber should pull the water pipes and wires to the wall according to the position of the tap of the switch socket. Remember to ask the water and electricity diagram of your decoration team and ask the plumber to tell you the route according to the diagram. Don't be afraid of trouble. The plumber's union meets your requirements. If you don't sign for it after the hydropower transformation is completed, the plumber won't sign for it. I want to take money from the decoration captain.

3。 Before positioning the water and electricity, it is best to ask professionals to test the water pipes of the new house. The property management company should do a 24-hour water cut-off test and check the circuit, mainly including 1.5 square meters of lighting wires, 2.5 square meters of socket wires and 4 square meters of air conditioning wires. Whether the ground wire is correctly installed in the socket, and whether the circuits in each room are correct, especially, it is best to use single circuit for air conditioning, bathroom, kitchen, bathroom, refrigerator, microwave oven, etc. If it is wrong, you should call back when the water is running.

4。 When positioning water and electricity, it is usually necessary to bring all bathroom manufacturers and audio companies. It is best to reach an agreement at the same time. If you buy solar energy, you should also invite solar energy suppliers. If you consider using water purification equipment. We also need to find business and discuss the distribution and positioning of water and electricity with the plumber. Of course, we should also consider installing gas water heaters and electric water heaters. Cabinet manufacturers and integrated ceiling merchants usually provide hydropower maps. It must be remembered that this refers to the plumber. You should comply with the requirements. You can call them if you don't understand.

5, hydropower positioning, it is best to consider the long-term, not limited to the current use needs. For example, in the kitchen, we mainly consider soybean milk, juicer, microwave oven, rice cooker, soup and so on. But I don't know what will happen in the future, so I have to install more sockets, which will be very convenient in the future. There must be several sockets on TV background wall, TV and DVD. Once ............. puts them on, you will find that the sockets are not enough. Some places should be fully considered, such as bathroom cabinets, air ducts and razors should be used frequently; If there is a socket in or under the shoe cabinet, you can use a shoe dryer.

What are the precautions for hydropower positioning?

6。 When installing the light bulb, please consider the placement of the workbench. Maybe the light is not in the middle of the table. Also consider the position of the wall lamp, preferably in the middle of the bed. The position of the socket must be calculated according to the height, spacing and possible furniture style in the future. If you don't have the style and style of furniture, maybe the furniture you bought is back, some sockets are blocked, and then it's not like this. .

7. Generally, the ceiling lamp in the bedroom and the ceiling lamp in the corridor should be considered to use dual controls, one by the door and the other by the bed, so as to avoid turning off the lights when lying in bed in winter. You'd better connect the wire to the bedside table. When watching CDs in winter, please don't get out of bed to change CDs and turn them off. From the study to the audio, video, network cable to the TV in the living room, movies and music downloaded from the Internet can be played directly on TV. Buy a set-top box biscuit, from the bedroom to the master bedroom or the guest room, so that the set-top box can watch several TVs (but not at the same time, which is the biggest drawback, that is, when you live, choose the channel in the room, change it in the bedroom, and vice versa. So when the living room is not looking, the bedroom can be freely chosen, which is equivalent to the set-top box moving to the bedroom).

8. Install spotlights or lighting lamps above sinks and gas stoves, and put a small lamp where vegetables are cut. Gas stoves are generally in the same position as range hoods, and some range hoods are also equipped with spotlights. For example, the Green Smoke Remover I bought has two very beautiful spotlights, and there is no need to separate the lights. If you buy a lampblack machine without a lamp, you should consider installing a lamp in this place to facilitate cooking at night or in poor light.

9. It is best to use all air conditioning sockets with switches, especially the bathroom electric water heater. Two-stage switch with plug is recommended. If you want to turn off the electric heater, it is dangerous to unplug it. When the air conditioner is turned off, just press the switch gently without unplugging it. Consider the location of the air conditioner when you get on the line. Move the power supply as close as possible to the air conditioner, so you don't have to look at the power cord when installing the air conditioner, leaving a little regret.

10, the switch of the whole house should be basically at one level, at least on the same facade. The sockets in the whole house should be on one level as far as possible, with special exceptions such as air conditioners and refrigerators. The colors of phase line and neutral line should be consistent in the circuit transformation of each house. If possible, it is best to indicate the colors of fire prevention, neutrality and control line in the contract. According to national laws and regulations, the protection line is yellow and green.

1 1。 The box at the bottom was buried. If you can, you'd better buy the bottom box yourself. If you don't buy it yourself, you should specify a universal bottom box. Some decoration companies cooperate with the switch suppliers of this brand and use the special trunk lines of this brand when wiring. After the circuit is completed, you won't buy this brand of switch panel. You can only be led. The nose is gone. As far as I know, the brands recommended by decoration companies are generally guaranteed. This is a price protection agreement. Even if you want to make a counter-offer, you may find it difficult to buy something really affordable. At present, the decoration company in Zhuzhou mainly promotes Simon, so I won't buy this brand of switch.

12, not too much lighting in the living room. It's simple. Don't turn your living room into a lamp shop. These lights and spotlights should be installed as little as possible. Generally speaking, the new house is moved and used many times during the visit, and the frequency of use is probably zero, just for display, but it is also very sanitary and troublesome. Don't think that the lamp is the last lamp. You don't have to consider it first if you have potential. This is not right, because the current wires are all dark, so when considering the location of water and electricity, it is best to look at the lights first. You should pay attention to the installation position of lamps in the whole house to determine the switch socket. Location, please ask the master of hydropower to help design the layout of the circuit, so as not to be too busy, and there may not be anything to see. When buying lamps and lanterns, we should also pay attention to: generally, try to use glass, stainless steel, copper or wood (shelves). Generally do not buy other electroplated iron, paint, etc. It looked good at first, but I don't know what it will look like in a few years. It's easy to fade.

Hydropower positioning is a very important part of decoration, which determines the layout of household appliances to a certain extent, so we must pay attention to the future layout of household appliances when positioning electrical appliances. The related contents of hydropower positioning are shared with you here. For more information, please pay attention to Tuba Rabbit.

Tubatu Online provides you with "every decoration quotation, 1-4 local decoration companies, 3 sets of decoration design schemes" and the decoration pit avoidance strategy for free! Click this link:/Zhu Ye /zxbj-cszy.php? to8to _ from = SEO _ zhidao _ m _ jiare & amp； Wb, you can get it for free ~