Introduction diagram of forklift basic operation and cab

1. Joystick: 1 Rotate the bucket, 2 rotate the boom. It would be better if you could read the indicator rod of the bucket, that is, turn the piston rod (telescopic steel) of the bucket upside down, where there is an iron bar.

2. Level the bucket first, then shovel it in with full throttle, then quickly pull back the No.2 rod for about 0.5 seconds, then pull it back (put it in the parking position), then turn the forearm, step on the throttle, pull back the 1 rod for 0.8 seconds, then send it forward for 0.5 seconds, then pull it back for 0.8 seconds, and then send it for 0.5 seconds.

3. After the bucket is shoveled in, pull back the No.2 lever (the boom is always upward), and then continue to turn the bucket. Stop the boom if the bucket cannot be turned over. If the shovel moves, turn the bucket over, so that the bucket can not only face the boom shovel, but also scrape off a little.

Extended data:

When the water temperature and lubricating oil temperature of the engine reach the specified values, it can only run under full load and negative load. When the water temperature and oil temperature exceed 363 K (90), stop the machine to find out the reason, and only operate when the water temperature is lower than 363 K (90), otherwise the engine will be damaged.

When the front and rear car bodies are angled, it is forbidden to shovel goods. Before picking up the goods, make the front and rear car bodies in a straight line, align and approach the cargo pile, make the bucket touch the ground in parallel, and then pick up the goods.

In addition to bulk grain, high-speed gear is not allowed to receive goods. It is not allowed to lift the bucket while driving. Bucket shovel loading goods should be balanced, and loading goods with bucket as the center of gravity is not allowed. Loading trucks are used for loading bulk materials and short-distance transportation, and digging with buckets is prohibited.