Job Recruitment Website - Recruitment portal - What is the salary standard for broadband installers?

What is the salary standard for broadband installers?

Guaranteed 1500+ performance+commission+subsidy+insurance = around 3000 to 4500. This place is different. Generally, first-tier cities are slightly higher, and second-and third-tier cities are lower.

Netizens are broadband installers:

When I was engaged in telecom maintenance, my basic salary was 590 yuan, transportation allowance was 200 yuan, telephone allowance was 160, meal supplement was 120, and maintenance fee (number of users in charge * maintenance index level, calculated according to 1 level in 0.7 yuan, 0.6 yuan in the second level and 0.3 yuan in the fifth level), According to your complaints and failure rate there, the installation fee (every household 16 yuan is installed on the same day, but every household 12 yuan within 24 hours, every household in 8 yuan within 24 to 48 hours, every household in 4 yuan within 48 to 72 hours, and over 72 hours in 0 yuan). If the user urges the installation, points will be deducted).

At that time, I maintained about 3600 users, but the telecom only counted that it had been used for more than three months, never stopped, and never reported a fault, so I only counted 2600 users for maintenance. In addition, the maintenance score is calculated in the whole district, that is to say, no matter how well you do, as long as a colleague in your district does not do well for various reasons, your score will be calculated as low. Moreover, you didn't maintain it well because of power failure, telecommunication trunk line interruption, computer room failure and other non-your reasons.

How does the broadband installer work?

This job depends on your physical fitness and your hobbies, and there are hidden dangers, such as unsafe factors such as aerial work. The so-called broadband maintenance means that broadband cannot operate normally. After verification by the account manager, the problem belongs to the bank, so you have to check it. Indoor installation, debugging, maintenance, this work is still in the past, busy is phased, generally ok.

Installation process:

1.? Install the CPE receiver outdoors where you can see the mobile signal tower, preferably where there are no obstacles.

2.? Find a suitable length of network cable to connect the crystal heads at both ends of the network cable, and connect them in the order of "orange white, orange, green white, blue, blue white, green, brown white and brown".

3.? Then connect one end of the network cable to the CPE equipment interface, the other end to the POE jumper, and then to the computer network cable interface.