Tips for making toilet paper box Steps to make bathroom waterproof

It is relatively convenient to have a toilet drawer, so you can put toilet paper in it. This way, you don't have to go to the bedroom or living room to get toilet paper every time you go to the bathroom. You can have a toilet directly, but you must know how to make a toilet drawer, and you can make a toilet drawer only after you master the method. In addition, what are the steps of bathroom waterproofing?

Tips for making toilet paper boxes

Step 1: Find an abandoned cylindrical plastic box and open a square hole near the bottom. First cut a hole with a fruit knife, then open it with a hacksaw, drill holes at both ends of the corner with scissors, and then cut it with a fruit knife. After the square hole is finished, clean the edge burr with a fruit knife.

Step 2: Drill two holes above the square hole with scissors, and then fold the iron wire in half and hang it through the holes. The third step is to hang the carton on the water pipe and warm air pipe in the proper position of the bathroom. If there is no water pipe nearby, you can fix a plastic pipe on the wall and hang a toilet paper box.

Steps to make the bathroom waterproof

1. Pave the slope with cement mortar or pisolite concrete. The trick is: the slope near the floor drain is large and the slope near the door is small.

2. Seal the pipeline with pipe root sealant, and the pipeline should pass through the root of the floor. When painting waterproof coating, you can stick 1-2 layers of glass fiber cloth to enhance waterproof performance.

3. The wall surface shall be polished clean and smooth, and there shall be no particle dust. Pay attention to the setting of the original angle and slope angle of the boundary area between the wall and the ground.

4. Polyurethane waterproof coating should be painted from the pipe root and corner, dried at room temperature for 4 hours, and then painted and scraped on a large area. Note that the total thickness of the coating is greater than 1.5 mm, and there can be no bad phenomena such as scratching and blistering. After 24 hours, the facade should be painted with the next layer, and then painted in the vertical direction for the second time. Finally, the film is semi-cured, and coarse sand particles can be easily mixed with cement mortar.

5. The setting of waterproof layer is related to the specific area. Waterproof floor waterproof layer is 200 wide above the ground, and the ground waterproof layer is 300 wide beyond the bathroom door. The waterproof layer of the bathroom wall with shower should be set to be 1800 wide above the ground.

6. At the beginning of the closed water test, waterproof work should be completed first, and then Pauling tube method should be adopted. Then it will be partially waterproof. In order to avoid damaging the waterproof layer on the ground, it is also unnecessary to do the closed water test.

The above article has already told you the steps to make a toilet paper box. The steps mentioned above are very simple. We can make a carton in a very short time, so just follow the steps directly. At the same time, I will tell you what steps to take to make the bathroom waterproof. Because the bathroom will often get wet, it must be waterproof.