Self-inspection and self-inspection of converter workshop in iron and steel plant

What are you asking? Is it a self-inspection project or a safety project? If this is a security project, I can shut down the system. As you can see, any safety responsibility system is to nip in the bud.

Safety operation procedures for each post in converter workshop of steelmaking plant

1. Anyone who enters the post must go through Level 4 safety education and pass the examination before taking up his post. Labor protection articles are fully dressed. No drinking before and during class. No fighting, reading, sleeping, leaving the post, visiting the post or doing private work in class. Concentrate and operate safely.

2. Before work, check tools, machines and slings to ensure that all appliances are safe and reliable.

3. The operator of each post can operate only after confirming the button of this post.

4. Strictly implement the Regulations on Command of Crane Gestures, command by whistling, and pay attention to self-protection.

5. No one is allowed to stand, pass or work under the heavy objects lifted by the crown block.

6. The hoisted object must be firm, and it can only be commanded to run after it is confirmed to leave the ground or equipment for more than a certain safe distance.

7. When lifting the ladle and scrap bucket, it is necessary to check the two side shafts and confirm that they have been hung up before directing the operation.

8. When putting the ladle, the ground must be flat and make sure that the ladle legs are in good condition. Only after the ladle is put away can it be commanded to decouple.

9. It is strictly prohibited to hang scrap steel and other sundries outside the scrap bucket. After the plug-in is cleaned, it can be hoisted for operation.

10. The metal level of ladle and molten steel ladle should be lower than 300mm along the ladle.

1 1. Don't smoke or carry kindling in areas with high oxygen content; Personnel are not allowed to stay in the gas area; Safety measures must be taken when working in areas with high oxygen content or gas areas. It is forbidden to store inflammable and explosive materials near oxygen and gas pipelines.

12. No one is allowed to work or stay before blowing, after blowing and under blowing. When adding molten iron and scrap steel, it is forbidden to pass in front of the converter. It is forbidden to pass behind the converter when tapping.

13. The pressurized slag agent should be added from the side of the furnace mouth, and other personnel must avoid it; Carburizing agent shall not be added to the ladle before tapping.

14. During the succession, the successor shall not operate any equipment without the permission of the successor.

15. It is forbidden to put anything on the fire-fighting equipment and air respirator, and there is a special person to look after it. Loss, damage and unreasonable use are strictly prohibited.

Safety operation procedures for foreman on duty

1. Seriously publicize and implement the safety policy formulated by the company and the factory department to ensure the safety of each team and the smooth progress of production.

2. When entering the production site, the labor protection dress must be safe and reliable, and drinking is strictly prohibited in and before class.

3. Abide by the rules and regulations of production safety, and immediately stop illegal and risky operations, and conduct criticism and education.

4. Seriously implement the responsibility system for production safety, solve problems in time when found, and solve problems without delay or leaving a tail.

5. Seriously implement the "five simultaneities" system and adhere to the "four misses" of accidents.

6. When commanding the crane to lift, the personnel on the platform shall be informed to pay attention to safety.

7. It is forbidden to command the crown against regulations.