How to operate Ningbo Zhonghui powder forming machine

Operation method of Ningbo zhonghui powder forming machine;

1. Debugging: Before starting the machine, clean up the sundries on the material cup and the machine table, and check the hexagon screws at the joint of the mold feeding device, upper and lower pressurizing parts, clutch and braking parts. Pull the flywheel by hand to check whether the punch is aligned with the cup. You can start the motor and try to idle. Normal operation: Add materials into the female die, and check whether the extruded product is qualified, then normal operation can be started.

2, boot, turn on the 380 volt power switch.

3, open the motor emergency button switch, in an emergency, you can press this button to stop working.

4. Start the motor button and the motor will start running.

5, open the control motor speed knife, adjust the speed knob, but the speed range of the equipment can only be adjusted between 0 and 400 in the first three months of use.

6. Turn on the clutch switch, the punch enters the material cup, and the pressed cake is automatically sent out. Powder forming machine is mainly suitable for producing powder metallurgy and mechanical parts with structural parts as the main parts. The hydraulic press has independent hydraulic and electrical systems and floating pressing, which effectively controls the forming density of products. You can choose protective demoulding and common demoulding. The electric control adopts PLC programmable controller, and the hydraulic system adopts advanced plug-in integrated valve to ensure the continuous, frequent and stable operation of the hydraulic press.