How to color with toner

According to the principle of pigment tricolor, marble glue+marble glue is used to adjust the basic color close to stone. Then add the corresponding color paste to further find the accurate color. This is the most common glue mixing method, and its advantage is simple operation.

Use dark color to deepen the dark part, you can use white to enhance the highlight, but after all, the neck should not be too bright in the dark, and the color used should be slightly darker than the face. This is the color used for the upper skin of the neck. You can also scrape off a proper amount of toner with a scraper to make it fall on the picture to be colored, or scrape it into a container or other white paper for later use.

Extended data:

Precautions:

1. In order to maintain the good effect of dye products, parts coated with toner dyes should be protected from moisture before drying.

2. When applying toner dye, pay attention to Bo Tu as much as possible, and don't apply it too thick. The coating should be uniform to prevent sagging.

3. Repainting time should not be too long (subject to drying). If the recoating time is too long, the toner film will dry and need to be polished before brushing.

4. When the dye daubing construction is completed or suspended halfway, the tools should be washed with water immediately. These are the precautions for the use of toner.

Baidu encyclopedia-plastic toner

Baidu encyclopedia-tiaose