Find the loading skills of loader. . How to load the car quickly?

Prompt 1: reverse the car to the best loading position.

Before loading the loader, pay attention to whether the dump truck will dump to the best position in the working area, which can save time and improve efficiency. Loader driver recruitment, specializing in hunting the driver market.

02

Tip 2: Think about the loading order before loading.

Think about the loading sequence before loading, and try to be close to the front of the car, because loading to the top will not say that there is a half shovel in front. Loader driver recruitment, specializing in hunting the driver market.

03

Tip 3: coordinate the combined movements.

Shovel in: Walk (forward), at the same time, increase your arm and level the bucket, that is, when you walk to the front of the pile, your bucket should be just in place and you can shovel in with momentum. Loader driver recruitment, specializing in hunting the driver market.

Bucket tilting, stick lifting and reversing are carried out simultaneously. When reversing, slowly lift the boom and straighten the bucket. After shifting into the forward gear, continue to walk and lift the boom.

Unloading: When you are not far from the trunk, you will start to unload the bucket, so don't worry about dumping, because if you move fast enough, the material will start to slide down because of inertia and won't come down immediately. After the bucket reaches the edge of the trunk, while continuing to unload the bucket, some booms should be lowered at the same time. After reaching the correct position, make the bucket just turn over and stop lowering the boom. At the same time, step on the brake again, and the material will be impacted by inertia.

04

Tip 4: master the loading time difference.

Be diligent with your right hand when shoveling. When the car is blocked, you should control the rocker arm of the boom more. Don't slam on the accelerator when the resistance is high, which will waste fuel and hurt the car, and can't improve the work efficiency. Loader driver recruitment, specializing in hunting the driver market.

05

Tip 5: Pour each shovel evenly into the carriage.

No matter how big the car is, it will always be square, surrounded by fences and scattered with sand and stones. If you only fall in the middle, you will definitely fall into a hill. "That's just the middle, and all parties are not satisfied, so you should control the position of each shovel and pour it into the car relatively evenly. Loader driver recruitment, specializing in hunting the driver market.

06

Tip 6: When it is almost full, flatten the higher part.

When it is almost full, you can push the material slowly and try to push the material as little as possible, because the loader can't rise so high when loading. If you need a shovel, put it in the back, because the front one is too full, and it will be inconvenient to cover it.

07

Tip 7: Put a shovel before and after sealing.

When reversing, you can use your eyes to see if there is any material falling under the carriage. If you find it can be capped, you can put a shovel in front and back to cap it, not too high, so as not to collapse.

The above loading skills are all from practice, hoping to help pilots. If you want to load a car quickly and well, mastering the skills is only the first step, and more pilots are needed to operate and practice.