Installation skills of installation lamp for hardware sanitary ware

1, when installing lamps and lanterns, you can save a lot of trouble if you install the sub-control switch.

Because if there is only one master switch and several lights are turned on and off at the same time, you can't choose the brightness of the lights, and it will also waste electricity. By installing a sub-control switch, you can choose how many lights to turn on at any time according to your own needs.

If there is an aisle in front of your house, it's best to install a switch at the end of the aisle, so that you can turn off the power directly after entering the door without going back to the door to turn off the lights.

2. The lighting system should be set to be adjustable, that is, it can be adjusted when the lights are dim or dazzling, and people will feel more comfortable and comfortable.

3. The color temperature of the light should be consistent with the atmosphere of the room, at least similar to the color temperature of other areas of the room.

Lamps can be installed on the top floor to reduce the shadow when working.

4. Don't just install a single lighting source in the center. In order to improve kitchen lighting, a multi-level lighting system composed of different lamps and light sources should be installed in the kitchen.

5. Installation location is also very important.

Linear incandescent lamps or fluorescent lamps shall be installed at the front facing the cabinet.

In this way, part of the light emitted by the lamp will hit the rear baffle, then reflect to the workbench and then hit the center of the whole space.

6. If the space is high enough, a transparent or translucent chandelier can be installed on the ceiling as a light source. At this time, the chandelier can not only provide excellent lighting, but also be a good decorative item.

7, lamps and lanterns installation, the most important thing is to be firm, you can pull by hand, feel it.

8, lamps and lanterns bottom cover should be close to the ceiling, can't shake.

9. If it is a chandelier, there will be a wire extending from the top to the lamp holder. It should be noted that this thread should not be too tight, and it should be loosely wrapped around the pull rod, otherwise this long-term tight thread will easily cause problems in the future.

10, check carefully, there can be no bare wires.

1 1. In addition, many ceiling lamps have scratch-resistant films on them, which need to be removed after installation. Anyone who uncovers them knows that it is difficult. Actually, there is a trick. You can blow this film with a hair dryer and then you can remove it very easily.