How to install the perforation of 33 perforated rotary camera

The installation steps are as follows:

First, the installation and adjustment of rotary tablet press mold:

1. Preparation before mold installation: Dismantle hopper and feeder. Open the right door and turn the handwheel to clean the working face, die hole and die to be installed. Radial

Pressure regulating pulley to regulate the pressure to the minimum. Remove the lower punch loading and unloading rail.

2. Installation of the middle die: screw the fastening screw of the middle die on the turntable out of the outer circle of the turntable by about 1 mm, and be careful not to collide with the powder suction nozzle and other parts, so as not to stress the middle die.

It is recommended to touch the head of the screw by hand. The middle die device is relatively tight, so it should be stabilized. Insert the punch into the upper hole, and then tap it in gently. After the middle die enters the die hole

If the plane is not higher than the plane of the turntable, it is qualified, and then tighten the screws.

3. Installation of the upper punch: firstly, remove the tongue, then insert the upper punch into the hole, and turn the punch with your thumb and forefinger to check whether the head slides down when entering the middle die.

Dynamic and flexible, no jamming phenomenon is qualified. Then turn the handwheel until the neck of the punch touches the parallel guide rail. After the upper punch is completely installed, install the tongue insert.

4. Installation of the lower punch: the upper punch is used for installation, and the loading and unloading track of the lower punch is installed after installation.

5. Typing operation: After the whole set of dies is installed, turn the handwheel to make the turntable rotate twice, and observe that the upper and lower punches enter the hole of the middle die and run on the track. No jam

And collision phenomena are acceptable. It should be noted that the highest point (that is, the film outlet) should be 0. 1 ~ 0.3mm higher than the turntable working surface. Close all doors, start the motor,

Idle for 2 minutes before use.