What problems should we pay attention to when posting wall covering? What are the steps of wall covering decoration construction?

Breathable wallpaper is also a good material for our wall decoration. It belongs to environmental protection products, and it is also a product that thousands of families think is cost-effective for wall decoration. However, wallpaper construction is also extremely demanding, so we must take it seriously, so as to ensure our decoration effect. So, what should we pay attention to when posting wall covering? This is also what we need to pay great attention to in the construction.

First, what problems should be paid attention to in wall covering?

1. After the primer coating is dried during construction, draw a vertical line as a standard to prevent wallpaper from being pasted by mistake.

2. Do not use a hard scraper or nylon brush behind the wall. Scrape from top to bottom with a soft brush to make the surface of non-woven fabric smooth, remove bubbles and wrinkles, and do not scrape the glue out of the seam to avoid pollution. If the glue is squeezed out, please wipe it off with a dry towel immediately. Try to keep your hands clean during construction.

3, should be checked at the end of the construction. When problems are found, stop the construction immediately, and find out the reasons and solutions. Non-woven wallpaper is the most popular environmental protection wall decoration material at present. At present, the base materials of non-woven wallpaper produced in the market are mainly imported, and the process is complex, so the price of non-woven wallpaper is relatively high, so when choosing, we must first make a good budget.

2. What are the steps of wall covering decoration construction?

1. Clean the foundation of the wall first, then put putty on it, wait until the wall is completely dry, then smooth the wall, wipe the wall flat and clean, and then apply basement membrane to protect the wall. It is not easy to get wet, and it has an alkali-resistant sealing effect, so it is not easy to destroy the wall covering in the future. If the wall is painted with latex paint, a layer of floor paint must be painted before the wall coating. Because latex paint absorbs water easily, wall coating can't be pasted. The concentration of floor paint is one set of floor paint and two barrels of thinner. Key points of construction: the wall should be dry, flat and clean. It is recommended to use basement membrane.

2. Before putting up the wall covering, the sanitary facilities must be cleaned, because wall covering has a large area, so as not to get dirty. It is best to cut wall covering with imported tools. The sharper the wall covering knife, the easier it is to operate. It can be cleaned all the time without muddy water. Don't cut with silk thread with a knife.

3. Unpack the rubber powder and the special glue for wall covering, pour 2kg of the special glue for wall covering into 2kg of water, and then use the machine to stir it into slurry. Please remember that the glue stuck on the wall must be thicker than the glue used for wallpaper to enhance the adhesion. In order to protect the wall covering and construction quality, it is best to use a new type of special adhesive for visual seamless wall covering. This glue is specially used for wall covering. After adding water, 20-30 square meters of wall paint can be added to produce two kilograms of glue. According to the wall material

4. Brush the wallpaper glue on the back of the wallpaper with a brush, paying special attention to the surrounding edges to ensure the construction quality. When the wallpaper is painted, the glued surface will be folded for 5- 10 minutes (be careful not to apply external force, so as not to crease the wallpaper, especially the cloth). After the glue has completely penetrated into the bottom of the paper, you can paste it, a few wallpapers at a time, in order.

Wall covering is also a very important aspect for our decoration, so we must understand it clearly so as to be satisfied with the decoration. Thank you for reading the article.