Design of stamping die, selection of die addition and design problems

1: The adoption of formwork must be based on standard formwork. Generally speaking, whether it is necessary to buy marked modules is considered according to the precision grade of stamping products and the economic strength of the factory. Your company's templates are usually made by yourself. Have you found that the template you made is as close as possible to the standard template? Our factory mold base is also made by ourselves, and we should also refer to the standard mold base when designing.

Their statement is valid. As a designer, craftsmanship is something you must know. For example, if I give you a stamping part and ask you to open a set of dies, how many steps do you have to go through and what steps are there? This is the craft. Is the basis of design.

3. Plastic die and cold stamping die are two fields, and they have nothing in common.

4. Mold wages are generally higher than mold wages.

5. Programming belongs to the category of operation.

The above is just my personal opinion, so it's a good idea!