Job Recruitment Website - Job seeking and recruitment - How to operate the new system of circuit board Tianma drilling machine

How to operate the new system of circuit board Tianma drilling machine

Operation sequence of Tianma drilling rig

1.

Clear data (click Start New File in the upper left corner)

2.

Open a new drilling belt (click Open Working File in the upper left corner).

3.

Parameter Settings (click Parameter Settings)

4.

Click the default (click the default at the bottom of the parameter interface, and the slot drill needs to be adjusted slightly, slowly).

5.

Set the tool magazine (F5 refresh the tool magazine, and then set the service life.

6.

Adjust the zero point (zero is required before adjustment, press the cursor key to adjust ctrl+w, and confirm after adjustment.

7.

Control the tooling (check whether the tooling parameters are consistent with the process card and the tooling control card, and save the data after confirmation)

8.

Save the data (click Save Edit File in the upper left corner to save it to disk D)

9.

All processing (F4 all processing)