How to use woodworking gong machine

1. Connect the three-phase power supply.

2. Connect the grounding wire to ensure that the grounding wire is good.

3. Turn on the power switch of the machine.

4. When the machine tool is running, check whether the rotation direction of the tool is correct and whether the parts are running normally.

5. Test the machine.

6. Adjust the machine tool according to your own needs.

7. After adjustment, put the processed workpiece on the workbench to complete the operation.

8. In the process of processing, if there is any abnormality, please stop the machine immediately for inspection.

9. When stopping the machine, the operator can only leave after the machine tool is completely stopped and the power supply is cut off.

Precautions for operation:

1. Operators should be trained and qualified to master the operation essentials of this machine tool.

2. Please cut off the main power supply when the machine tool is in maintenance or not in use.

3. Always keep the machine clean and lubricated. Before starting the machine, check whether there are foreign objects such as wrenches and bolts on the machine tool, and remove them.

Clean it up Check whether the cutter, spindle, lifting handwheel and backup plate are in good condition. It is locked to make it work in a normal state to ensure safety.

4. When using special-shaped blades, the extension, compression and balance of the blades should strictly meet the safety requirements.

5. When operating, concentrate and gain a firm foothold.

6. The machine tool should designate a special person to be responsible. Non-operators are forbidden to touch switches, knives, etc. To avoid accidents.

7. When milling small workpieces, appropriate fixtures should be used.

8. Only when the spindle reaches the rated speed can milling be carried out.

9. The machine tool spindle sleeve, lifting screw and other moving parts should be lubricated regularly. The spindle of this machine runs at high speed.

The rotating parts and spindle bearings have been filled with appropriate advanced grease during assembly, and after running-in test for a specified time, they meet the technical requirements.

Security code:

1. Please read the product manual carefully before operating this machine. Check whether the grounding wire is firmly grounded and whether all components are normal.

Whether the operating position is bright and shadowless. Note: (Operators must undergo strict training and read the safety operation rules carefully before operating. )

2. Woodworking milling machine is a high-speed machine tool, which must undergo strict inspection before use to ensure good dynamic balance performance. But in the production process,

In the process of use, if the dynamic balance of the placed parts is changed, it may cause great vibration, and long-term vibration will cause serious mechanical fatigue, thus accelerating the damage of parts and leading to accidents.

3. Do three tights and three different attentions when operating. Three tights: tight clothes, tight waist and tight axis; Three noes: no tie,

No jewelry, no gloves; One note: pay attention to protect your eyes.

4. Before starting the machine tool, please pay attention to the danger warning signs on the machine tool.

5. Check the rotation direction of spindle and cutter.

6. Do not approach or touch moving or rotating parts during operation; Do not move sundries, adjust the machine tool or move sundries.

The power supply must be cut off first, and the cutter shaft must stop rotating completely.

7. After the tool becomes dull, please replace or sharpen it in time.

8. Don't go beyond the working range of the machine tool to prevent unsafe or machine tool damage.

9. If any abnormality is found, immediately stop the machine for inspection.

10. When the operator leaves the machine tool or loses power, the main power switch must be turned off.

1 1. When stopping, the machine tool must stop completely before the operator can leave.