The welding detection signal of otc welding robot is gone.

The deposition detection signal of OTC welding robot is gone, which may be caused by the following reasons:

1. The deposit detector itself may be faulty. This may be caused by long-term use, improper maintenance or aging of parts. In this case, it is necessary to check the working state of the deposition detector and repair or replace it if necessary.

2. There may be something wrong with the signal line of the deposition detector. The signal wire may be loose, broken or have poor contact, so that the detection signal cannot be transmitted to the control system. In this case, it is necessary to check the connection state of the signal lines to ensure that they are tightly connected and not damaged.